VW MK 4 trans swap 01M 2 of 3, wiring 

Im so glad I found these vidoes because it made my swap a lot easier to accomplish. I took the car out for a drive tonight after getting it all the way back together and it worked as if it has always had a manual transmission.....thank you for sharing your knowledge

That wiring instruction, pretty good! Thanks! im swapping an 02j to a 1.8T on a Beetle, and everything makes sense, and right, its pretty straightforward, thank you very much!!!!

I got a donor car. Swapped in all the actual components, that was easy enough. Will be wiring today. Thanks for taking the time to make these videos. I'm gonna try to use the donor cars underhood to PCM harness to cover that part. Ill check back later to either report good news or to look for where I went wrong.

I’m doing this swap and I have a 2004 1.8t auto with the 09a. Pin 39 is already taken with a white w red stripe wire. Its not going back to the TCU. Any idea why that is or what I should do next?

I just did the swap on a 2000 Beetle Alh. Excellent job talking through all of the wiring for this swap. The car drives, cruise control works, however, my tach does not. Do you have any direction to point me into or know what i may have done wrong?

I need help! I’ve been trying to fire my swap up and it has just been a nightmare. I have all of the circuits ran correctly everything works, (cluster, reverse lights, door lights, ect) except for the starter? I haven’t messed with any of the starter wiring and I just can’t figure it out. My relay 100 is also clicking when I try to crank the car. Please if you have any help it would be a great help! Appreciate it

Great write up! So I followed everything exactly and used the multimeter to double check everything. I have a 2.0aeg from a 2001 golf. Everything works but the car won’t start. Clutch pedal works and starter engages but the car won’t allow spark. I am getting fuel but no spark what could be the issue?

Is the check engine light on for no communication between the tcu and ecu?

Hi, I'm in the process of swapping a manual trans in my 2004 BEW wagon, I followed everything in your video, but I ran into an issue with the ecu wiring. My ecu is EDC16 and the pinout doesnt match the diagram. I already have a black wire connected on pin 43 on the ECU (the passenger side connector with 60 pins) Any idea?

Bonjour, j’ai commencé mon swap avant de regarder votre vidéo, j’ai swap et toute la partie faisceau moteur d’une voiture manuelle, la voiture ne démarré quand même pas donc j’ai mis le relais 53 et elle démarre. Par contre je n’ai pas de feu de recul pas de vitesse kilomètres heure est mon voyant d’huile allumée alors que j’ai de l’huile ! Est-ce que en faisant votre manipulations, tout rentrera dans l’ordre ? Excusez-moi, je suis français et je parle très mal anglais

good day, i've got a mk4 golf wagon with a 1.6 bfq engine which had a 01m auto transmission, it does not have cruise control. i did a manual swap to a 02k (rod type gearbox) but it isn't starting (not even turning over). do i have to do this same wiring and will it work?