Тёмный

Weber 48 IDA Basic Tuning Guide for Rotary 

Castellaw Speed
Подписаться 1,1 тыс.
Просмотров 5 тыс.
50% 1

This is a very basic guide and overview of the parts in a down draft weber.
www.timsroadster.com/html/tuni...
The above link has died the same death alot of the internet is going to have with all the consolidation. Please donate to the great people keeping these old pages alive for history below and enjoy the preserved knowledge.
web.archive.org/web/201703190...
Comment, Like, and Subscribe for more.
Follow the race team @WastingMoneyRacing
wastingmoneyracing.com

Авто/Мото

Опубликовано:

 

27 июл 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 7   
@zeebass2690
@zeebass2690 4 месяца назад
I have a 12a bridgeport. 40mm chokes, F11 tubes, 185 mains and 130 air correctors, 20 deg timing locked dizzy. 3rd progression hole.
@carguybrad3107
@carguybrad3107 2 года назад
Thank you for the informational video! I’m going to start a 12a Miata swap soon and plan to run a Weber carb but not sure how to run ignition. Planning to run a MSD ignition, what are you planning to do for ignition?
@CastellawSpeed
@CastellawSpeed 2 года назад
Planning on using a haltech elite 550 to control ignition but you can use a fb distributor to control spark and such. I have a brief overview video on it.
@jordanwaddell5831
@jordanwaddell5831 Год назад
Say you have your car idling nicely, it drives nicely, you have your mixture screws at a nice spot (at least I think so) but it bogs down so to speak when you pump the accelerater down quickly. You hear the revs climb but then dies off and and your motor is about to stall unless you take the foot off the accelerator. What webber part would you then be looking at to change and why? Thanks in advance!
@CastellawSpeed
@CastellawSpeed Год назад
Depends on the bogg and where you stab it in the rpm range
@juanmelissagarcia5981
@juanmelissagarcia5981 2 года назад
What are you using for a fuel pump and regulator?
@CastellawSpeed
@CastellawSpeed 2 года назад
Carter p4600hp and a bypass regulator
Далее
МОЙ НОВЫЙ ДОМ
1:01:04
Просмотров 2,1 млн
Kettim gul opkegani😋
00:37
Просмотров 906 тыс.
Flushing an engine with paint remover - will it work?
14:32
How to Choose Your Axle Gear Ratio
19:15
Просмотров 1,6 млн
Crank modifications for increased power Part 1
27:24
Просмотров 315 тыс.
Bore vs Stroke - What Makes More Power?
15:15
Просмотров 1,6 млн
How To Perform a Compression Test - EricTheCarGuy
10:00
Догоняю догоняю
0:30
Просмотров 745 тыс.