Welch Plug or Core Plug on a Carburetor- Remove Without a Drill - Easy! 

I just used your method and it worked Great. I don't own a drill or good self taping screws so I used an awl from a Swiss army knife to make a starter hole then used an screw eye to screw into the plug. I liked this very much because it got really hard to turn and I had to use a pair of pliers to turn the screw eye. I could not have done that without the screw eye head to grab into with the pliers. I was a little off center, but it worked just fine. Thanks.

Thank you, your videos have been extremely helpful and very informative. Countless topics to be learned as a result and anyone can benefit from them. Again thank you for taking time to share.

Using a self-taping screw was very impressive. All other removing styles needed a drill. I really like you alternative method. . Thank You

Another very helpful video. You have lots of tricks up your sleeve. Thanks for sharing.👍👍

Worked great. Outboard running it’s best now.

Well done sir! Indeed a better alternative.

Very helpful. I’ll try it.

Thanks for sharing this informative video

very nice. is it possible that the Welch plug is under the carb in front of the air intake hole??

Good video..

Thanks

If this plug was put on while manufactured, why do we have ot remove it? I'm just curious what those little holes inside are for?

When I tapped the screw onto my plug to try and thread it through the plug only sunk down to the air screw. Trying to raise it back up I broke a small pick off in the pilot hole. Any suggestions now?

Do they make those plugs out of plastic also?

Can a carburetor run without a wlech plug?

How can you do it and save the Welch plug ?

I usually just produce a picture of my ex-wife - they come right out and leave the room all on their own.

Plasma cutter?🤪