Welding A Pontoon Boat

Подписаться 19 тыс.

Просмотров 7 тыс.

50% 1

In this video we show you how to properly weld a hole in a aluminum pontoon boat tube. Thanks for watching & subscribing to TVWeld!
Don't forget to check out our new welding help group on Facebook below!
/ 434897374657375
#tvweld
#brentharkness
#pontoonboat

Опубликовано:

2 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 15

@splitlipceo6864 3 месяца назад

Excellent knowledge and demonstration, very well done. You said you were using a stainless-steel wire wheel? Are there any alternatives or is stainless the must-use? Also would there be a scenario of using a "patch" as in a separate sheet/piece of aluminum to fix a large hole/crack? One last question but is pulse/pulse an absolute must? I've been doing flux on mega marine industrial pieces and I'm trying to hone the aluminum skills. Your video has helped immensely, thank you very much!

@TVWeld 3 месяца назад

If you use a carbon steel brush it will leave small iron deposits on the aluminum which will rust so stainless is a must. I've done patches on big holes, but usually the crack is so small you don't need a patch. Pulse on pulse is not a must but it sure is nice. It keeps everything nice and cool!

@splitlipceo6864 3 месяца назад

@@TVWeld Excellent, this info helps a lot! Thank you very much!

@davidsumpter1 Год назад

Man I watched this video last night with a pontoon job today, I feel that double the money statement lol

@TVWeld Год назад

They always try to fix it themselves! JB Weld for sure.

@richardhendrix425 Месяц назад

How do I fix my mistake of putting silicone on my cracked pontoon?

@TVWeld Месяц назад

Get as much off as you can. I'd wire wheel it, then cook it with a torch (don't melt the aluminum), then wire wheel it again. Weld it. If it looks contaminated, grind it off and re weld it. Do that as many times as it takes to get a good looking weld that is not contaminated.

@richardhendrix425 Месяц назад

Thanks. What do you think about mineral spirits?

@TVWeld Месяц назад

@@richardhendrix425 I've never tried mineral spirits.

@jumongmunar9125 Год назад

Good day to you sir ,may I ask what is the difference between Mig and Mag Welding?

@TVWeld Год назад

There is no difference. MIG is an improper term because there is an active gas in CO-2 which is used in the shielding gas so they switched it to MAG. The AWS proper name is Gas Metal Arc Welding or GMAW but most people will know what your talking about if you call it MIG welding.

@jumongmunar9125 Год назад

Thanks for answering my question

@jaredhammonds8255 Год назад

The drip was a dead give away but I didn't expect that much water to be in it. Great video my man

@joelcolvin92 4 месяца назад

Do you prefer push pull gun over tig? Last person who repaired my boat used a spool gun got lack of fusion and had to end up redoing the whole top portion of my bass boat.

@TVWeld 4 месяца назад

All day long. Lincoln 350 MP Power source with a python push pull gun. Best set up by far.