Weller WX2 Micro Soldering Station Unboxing!

Подписаться 968

Просмотров 1,3 тыс.

50% 1

Weller WX2 Unboxing! Its finally arrived and I'm super excited! Join me while I unbox this beauty and run it through its paces on an old PCB.
The Weller WX2 Base Station is available here (affiliate link) : amzn.to/2UgKg1n
If you would like to support the channel, any donations would be massively appreciated and will help me bring you better and more quality content. Please consider visiting / retrotechno

Опубликовано:

16 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 5

@ynm078 2 года назад

Hi thanks for the video good info I'm looking at this soldering station. How good are the tweezerers ? Have u used the 10mm ? Have u been able to take larger ics considering its only 40w per side I'm just wondering that's not powerful enough to remove ics

@martinmeyer2008 Год назад

Hiya, I haven't gone up to 10mm, the largest tweezers I have now are 6mm. They take small IC's off with no problem. For me, anything bigger - I'd switch to my hot air station. I suspect you are correct and 10mm might be pushing it, though if they make them, they must have a use! :-)

@alexstone691 3 года назад

Does it also use 24V for the tips? also do you maybe know the pinout of the handle connector??

@martinmeyer2008 3 года назад

Sorry, nope, these are all 12V tips and the 24V tips are not backwards compatible. Nobody has the full pin-put, its now got a lot more complicated as the newest WX-series has an accelerometer in the handle instead of a reed switch, and there's an EPROM doing temp control etc, so the comms via the cable are probably digital now and not analogue....somebody would need to probe them and reverse engineer them to get the full picture.

@alexstone691 3 года назад

@@martinmeyer2008 thanks a lot, had a hard time getting any info on it