Hello I accidently short-circuit one of the SPI connection with a led that was wrongly wire. The SPI output do not respond anymore, do you know which piece to change on the board to fix that ?
If you open up the unit there are “automotive” type fuses inside, unplug the unit, set your multimeter to continuity, and check every fuse with it, then replace blown fuse. You can buy those fuses in any car shop.
hi, i burnt a bc204 plug in into DC, i know i'm stupid as hell. opening it i see a capacitor 47uf exploded and the ''u7'' component also a little burnt, taking pictures i saw (the letters that remain) says something that 509 on the first row, E1 in the second row and 9 on the third row. i don't know if i can replace them or i'm totally over. Thanks in advice
i'm pretty shure that the component i'm talking about is the one that comes after ch3 on the BC216. U1 i think. being C2 the capacitor one that exploded. is that component available?
Hi, I have BC-216 and probably short-circuited on of the ports. Now only the first pixel on every led strips lights constantly and test mode does not work. The menus and connection from my computer is still working. All the fuses inside is tested and working. Any suggestion if it is repairable and which part is causing this?
Thanks for the quick reply :) I will have someone professional to test this. Can I buy IC directly from your store if I also buy something else or another BC-216 unit? Tried to google a IC number "94 A7P1K G4 HCT245" but did not find anything(not my field).
Sorry I replied to wrong comment. Unfortunately I don’t have a store. Hopefully in the future once my channel grows. Have you scoped out the signal from the port to the processor?
Hello, I have question, can you help me with product BC-216 artnet? The connection was broken during the update and lcd screen frozen on "Update the firmware" and its not working. Can you help me?
Hi, you will have to upload firmware through programming port located on the right side on the main board, you will need: a programmer for arm processors, firmware, and some knowledge in programming. Then you can attach the programmer to four pins just on the right of the arm processor, they are 4 vertical holes they would fit Dupond connector. And flush new firmware onto the chip.
@@MaxELECTRONICS Its look like complicated way :D Can I just someway restart all device or restore to factory settings? But I have other question, where can I download latest firmware fot BC-216?
No unfortunately if your firmware is corrupt you have to re-flush through the programmer. Also I had a look I can’t find firmware ether, I don’t know who the manufacturer is, I think it’s genetic device, meaning it’s made in small factory in China and very hard to trace who makes it.
sir..can you help me with this unit?i just buy it and i can't connect it to resolume...i checked up my adapter setting in my pc it says "unidentified network"...so i run the diagnostic but it keep saying no valid ip config... i use win 10..thanx before..
@@MaxELECTRONICS i've try using both router and crossover cable..but it still won't connect...it keep saying unidentified..when i diagnose it say does not have a valid ip configuration...any suggestion?
