Why you can't fix a Can Am ATV power steering unit.

Подписаться 63

Просмотров 44 тыс.

50% 1

The only thing easily replaceable is the motor. The circuit board is glued into the cover and would be more work than it's worth to try to remove it, repair it and then re-glue it so it's waterproof.
This one passed all the tests in the service manual and the speed sensor works on the ATV. We installed a used one off Ebay and my step dad's 650 has power steering again. Taking off half the front of the ATV is the time consuming part.

Авто/Мото

Опубликовано:

27 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 28

@cendon1 3 года назад

Hello friend I appreciate your contribution and I searched a lot but there is not much information about it I have an xmr 1000 2013 and I have a fault in the DPS since it is only working for the right but for the left it is very hard so I have it disconnected I think it has solution or do I have to replace the whole part?

@duanezink 3 года назад

Did you crash or bend anything? Does the computer show any error codes? If not, my guess is that it is not repairable. The good news is that you have a G2 version and you should be able to buy a good working used unit for it. Mine is a G1 version and I have not found a way to install a G2 unit into a G1 quad and have it work.

@brianerickson7210 7 лет назад

very nice!

@user-jh4ck2ld4r 5 месяцев назад

I have a 2024 850xt Max. Just started to notice a twitchiness in my steering when sitting still . If i move the bars a little bit, they jerk back n forth slightly but quickly. . Calling dealer in morning. Got any thoughts before i talk to them ?

@duanezink 5 месяцев назад

I would make sure the battery is fully charged and the connections are clean and tight. A poor ground might cause that.

@user-jh4ck2ld4r 5 месяцев назад

@@duanezink I'll do that. Thanks

@user-jh4ck2ld4r 5 месяцев назад

@@duanezink Thanks. It was a loose connection.

@duanezink 5 месяцев назад

@@user-jh4ck2ld4r Nice!

@dustinmorgan9871 4 года назад

how do you rebuild/repair motor. I have a 13 800 with dps that's not working

@duanezink 4 года назад

The electric motor can be taken out and repaired. You would have to source any needed parts such as the brushes, etc. If something in the circuit board failed, I think you just have to get another unit since they don't sell individual parts. As far as I know, a G2 unit should bolt in and work. Don't hold me to that though. We only have G1 quads here.

@dustin17aa 4 года назад

@@duanezink ty.. I disassembled it and took guts out for a direct steering. Still a little hard to turn but it is better

@usa1144 5 месяцев назад

If the ps motor locks up on a 2011 outlander 800 xmr....will it lock the Handlebars up so the atv can't turn right or left? I mean....I can't even turn my Handlebars manually with the front tires off the ground. My dos settings aren't working either. I also have check Air Suspension message being displayed. It says I have no active fault codes tho. I put a brand new correct battery in it as well. What's my issues ?? Thanks for any advice. I'm stumped. Only 1,000 miles on my canam too. 😔

@duanezink 5 месяцев назад

I don't remember if it will lock up. I just read online someone posted about it being really hard to turn. There was an issue with the large yellow wires under the seat being too small. They have a kit to fix that. It could be your problem as poor voltage from partially melted wires will cause all sorts of electrical troubles.

@trbgeneralconstruction555 6 лет назад

I have a 2017 can am xmr 1000 as o was ridding yesterday show a message check dps What are my steps to try to fix it before knowing that it won’t be hable to get repair. ?

@duanezink 6 лет назад

It can be just a low voltage problem. Make sure your battery is fully charged and not starting to go bad. It could show normal voltage but fail a load test. You can even try disconnecting the battery for a few minutes to see if it helps. If you turn the bars and it feels jerky or twitchy, it's probably on it's way out. There are some tests in the service manual or you can take it in to the dealer and hook it up to the BUDS software to see if it shows anything.

@renanton1069 Год назад

Yah, in sure you ask saw what these machines can go through, and you all know what water does to a curcuit boa board.

@allen5044 6 лет назад

Is the shaft that runs through it replaceable?

@duanezink 6 лет назад

I would think so, but it's not available as a new piece. You would have to swap one from a used one.

@beliefisnotachoice 6 лет назад

what did you pay on ebay for the used one?

@duanezink 6 лет назад

$365 in April of 2017

@jasoncooperpcola 6 лет назад

Do you still have the unit in this video?

@duanezink 6 лет назад

I gave it to my brother in law. He wanted to try to use it on something he was creating. Not sure if he still has it in one piece. Why do you ask?

@dennisisaac746 3 года назад

What code was it

@duanezink 3 года назад

I tried to look back and find an old post about it but can't. Sorry, I don't remember the actual code.

@denysgagnon6158 2 года назад

J'ai un spyder rt 2010 et j'ai du changer mon dps au coup de $2100.Peut ton reparer mon ancien et quoi faire avec peut ton le vendre pour le faire reparer

@duanezink 2 года назад

I do not know anyone who can repair them. I had to buy a used one.

@tylerduke8212 4 года назад

I cant believe how stupid people are to think it's ok to buy a 4 wheeler with power steering. It's a 4 wheeler why do you need it and it's very dangerous

@renanton1069 Год назад

Ok, you need to do lots more trail riding, when you get to rocky trails if you don't have power steering when you come off of big rocks it can knock the handle bars out of hour hand, I've seen a couple people get thrown off the machine, it's not stupid, there's a purpose.