Why you need to step up to a FLUKE Clamp Meter w/ Fluke Connect 

Good info. I got my 376FC on buya for 220.00 and picked up a fluke TS100 on offerup for 100.00 I bought used flukes cause in 40 years of working with them, I've never seen one go bad

Step up with fluke lol. Sadly I bought the 378 fc and found out it doesn’t work on the output of vfds with the clamp or field sense . Plus the field sense is so inaccurate +/- 20 volts . My 200 dollar amp clamp is able to read the output of vfds and is way more accurate . Overall I was highly upset to 800 dollars for something you can barely use in a industrial motor control panels

The difference between 377 FC and 378 FC: Clean quality power when measuring. What is that meaning? Example: You're measuring the electrical circuit/wiring in a building. When measuring for amps, the reading could be higher or lower than what it should be for that circuit. Why would the reading be higher or lower? Possible reasons: a loose connection somewhere in the circuit, or possibly a short in the circuit. Could also possibly be from ghosting. The clean quality power feature will be able to tell you such a problem does exist in the circuit, that a problem does exist and needs to be corrected. That feature is well worth the difference in cost when you learn how valuable the feature actually is. You work in an industrial environment with high voltage equipment, you definitely need that feature. In that scenario, the tape helps efficiency in locating hard to detect problems in the circuit.

can the app be used as a stand alone, without paying for it? Don't need to upload anything, just want to view on my phone but not pay for an expensive subscription. Thanks

Can ANYONE tell me how to ZERO OUT my Fluke 376 FC... EVEN when I turn it off and back on again, and toggling the min max / hold button features, it WONT stop displaying 1.5 Amps in the DC CURRENT knob selection mode.... This is frustrating ‼️ BTW, when I open the Jaw up it reads ZERO, but when I close it, it goes back to 1.5....

Fluke connect software is unreliable and needs a lot of work before I'll use it again.