Wine Bottle Bird Feeder 

Great idea with the Sharpie - there are always new and smarter ways to do things if you are open to them.

Yeah, either way, cutting the line or leaving the line is ok. I guess one question would be about the marks on the tape measure. Would you mark on the left side or the right side of it. They are probably around a 1/16”, so not much, but if you pick one side and use it to measure where the piece is going and use the same side to measure the piece, then all is good. And if using a roll up tape as opposed to a steel rule, it doesn’t hurt to check the hook on the end of the tape occasionally. The holes can wobble out in time and your outside measurement might not be quite the same as the inside measurement. And make sure the hook is pushed in or retracted when doing an inside measurement. Again it’s not going to be much, but if you’re looking for exact it might be enough. The main thing is to be consistent. Measure everything the same way, try to use the same measuring device for the entire project, and use the same marking tool whether it be a sharpie, mechanical pencil, marking knife or whatever.

Thanks! I wanted to make something others could duplicate easily.

@@jerrystark6766 Thanks!

Thank you very much!

@@blackwingvisuals5017 I used a hole saw - quick and easy. I cut halfway through, flip board and then complete cut from other side for a nice clean cut. A spade bit would work but would need another backer board under it to avoid "blowout" on the backside.