Wireless DMX Install Tutorial - Simply Frank Da Mad Scientist 

Yes, I do this all the time... I actually hook up my led uplight inside my truss so it can receive DMX, and send it up to the top of my truss to the moving head

I have never tried that, I would probably need to know where the voltage converts from AC to DJ and then measure it... That's a little more complicated than I can do

It's Called the Numark Orbit Controller... wireless midi device, it was really cool... www.numark.com/product/orbit

chinese 90 watt generics

Is the also a Video Converting moving Heads? What is, if i want to go one time with dmx cable but installed the wifi module at Same time (e.g. In case my transmitter Crashs) Great Job& Video.

Yes

I don't have an ADJ Tripar, or else I would check for you, but there are some IC chips on the broads... some will have $5v going through one of the pin... Either that or look for a 7805 transistor and that one for sure will have 5v

on the 8 feet chip you will get the 5v i have the picture i can send you for the 5v

the dmxcart cna transmit and receive itself

Yes

You can use a rechargeable battery such as the Lithium Ion 18650s or 3 AA Batteries in Series to get you to 4.5v

I would not suggest you buy these lights.. They are from ebay.. 4in1 RGBW led Lights..

For the program on this video, that one is called Q+ Light show (something along the lines) I loved it but it's not 100% working with my moving heads. The other program I use now is freestyler. Most Wireless DMX receivers are transmitters as well, They are smart... if they detect a dmx signal present on the pins... they automatically transmit... if they detect a dmx signal that is already being transmitted wireless, they become receivers..

Charlie Valenzuela

I purchased directly from china, but I can show you something similar on amazon... www.amazon.com/Wireless-Transmitter-Receiver-Modules-Controller/dp/B093FXH6W6/ref=sr_1_2?dchild=1&keywords=wireless+dmx+board&qid=1622851322&sr=8-2

Hi FPV Zone, that depends on the light. Most lights do not run wireless dmx on master/slave. Master/Slave is not a DMX signal, but a proprietary signal. I have one company that does run Master/Slave DMX and they can control other wireless lights. But the majority do not run a dmx signal on master slave.

How do you mean?

DJ Francisco Perez the pcb board that is attached to the DMX connectors has 3 solder pads with holes for the wire to pass through for soldering.

You mean the ones pictured at 6:05 right?

DJ Francisco Perez Yes sir

Yes, you are right, I still prefer to solder to an existing contact.

Video Is 6 Years old, I needed better Lighting, better camera, and better video editor... :)