Hold the button with the red circle srrounding it pressed until the circle starts blinking.
If you hit a snag here there will be further instructions at the end.
After putting the batteries in your thermostat it should start up automatically, showing codes for programming versions etc.
You’ll find that the display has UFH blinking which stands for UnderFloor Heating. It might have said rAd, for radiator, but you can change it to UFH by pressing the button with an arrow pointing up since we’re handling underfloor heating.
Then press the button with a check(tick) marking, we’ll call it OK. That makes Join appear and then Pair which is what we want to do so we press OK again.
UU1 apperears, which stands for the connection box. Since there’s only one that’s correct.
By pressing the button with an arrow pointing right, we move on to the number on the bottom right that indicates which of the 8 coils we’re controlling. Since it’s number one we’ll press OK.
Now with one programming done you can set the time etc. Instructions come with the product.
This is where we press the button with an arrow pointing left to get a ring market around the sun. That gives us an even temperature throughout the day.
To make sure the programming worked we raise the temperature to near max, (for example 35°C). The cycle takes a couple seconds so we might have to wait for the green light to shine by coil 1.
When we then turn the temperature down to the wanted temperature and press OK the green light should turn off.
Repeat the same procedure with every coil until you’ve gone through them all.
End programming by pressing the first button we pushed, holding it until the ring is lit continuously, and you’re done!
If however you ran into a snag right at the beginning, and the lights are double-blinking, you won’t be able to programm anything until you reset.
Hold the button down until it shines continuously in orange which come safter the blinking.
Then hold the pair button for about ten seconds. That should make the two other diodes blink red once. After that you just press reset (preferably with cometing narrow and pointy), and you’re reset and can do as explained above.
3 июл 2019
