I'm only speaking for myself but I appreciate the time and effort y'all put into the videos. I really enjoy watching you and your crew at the mill. It kinda looks like your roller bed needs to be raised just a smidge so that boards that are just cut will be brought off of the feed belt by the blade, maybe im not seeing it correctly either.
Thank you, and I agree that some time I need to work on the roller beds. The height needs to be better and there needs to be more roller. I appreciate you watching and commenting
Good video, it's a shame one got lost. As far as editing...for one of our 15 minute-ish videos it'll take 2 evenings. One evening seeing what the footage we got and thinking about it, the next evening putting it all together. We use 2 and sometimes 3 cameras and that really adds to the editing time.
Thanks for the info. Most don't realize the amount of time is involved to upload content. With that being said I do find it satisfying work though. I appreciate all you do and thanks for watching and commenting
maybe you just need to find the right software for editing a video. As far as the grease fitting, it sounds like it needs to be pulled and the entire chamber cleaned and debrided. You might have a metal particulate deposit built up which is clogging the works.
I was hoping someone would think it would be good to unbolt that and clean it out. I'll try that for sure. I probably should look at more software. There has to be a better kind than what I'm using. Thank you for watching and commenting. I really do appreciate you
most of the time when a grease fitting won't take grease U can sometimes use something sharp and push the check ball in and see if it works the whole grease fitting may be stopped up I say it may be from old grease then U might have 2 put new grease fittings in U try and see if U wash the old 1S out clean and most people find metal in a log they dig out and U do what U have 2 get it out or U will be putting a new set of saw bits in the saw blade a nail is bad enough that will ruin a few saw bits it's takes time 2 change them out then U have 2 use a saw blade wrench and a nail or a steel pin 2 change the bits take the old 1S out and put new 1S in 😊😊/ that other machine U might have use the bucket 2 get the track off the ground it might work that way so U can grease it I haven't work on them be 4 is there anybody close by U ask about it 😊😊 OMG 6 3O 2O24
I have tried changing the fitting, heat with a torch, jacked the track off the ground, power pack into the fitting. Next thing I'm taking the entire carriage off and put new bushings in. I appreciate you taking the time and helping
