Yaesu G2800 Rotator Alignment | Troubleshooting Rotator Speed Control

Подписаться 7 тыс.

Просмотров 1,3 тыс.

50% 1

I tried troubleshooting as to why my Yaesu G2800 speed control to the Left wasn't working as it should. I opened up the rotor to take a look inside. Additionally, I show you how to align the rotator. Thank you for watching!
#rotator
#yaesu
#2800
Donation Tip Jar: www.paypal.com/donate/?hosted...

Хобби

Опубликовано:

9 мар 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 11

@thomashenderson603 4 месяца назад

i know when i did mind, I had the wrong marks on the rotor when alignment. And the 270 was really 450. Finally found a you tube video and used the right marks and it worked.

@JayN4GO 4 месяца назад

Thanks capt. It’s still not aligned even though you did use tape. These can be a pita

@rogerp5816 Месяц назад

The problem is in the controller. Start by check the voltage between pins four and five. The polarity will reverse as you change directions.

@DarrenN4VFR Месяц назад

Yup, I will when I get a few days off.

@mervyn374 4 месяца назад

Will be handy to know (when you get it back), what is the cure for that problem . 73

@DarrenN4VFR 4 месяца назад

I sent my rotator to Yaesu to have a look at it.

@mikegianfrancesco9431 4 месяца назад

Maybe control cable

@JuanjoGameroLopez 2 месяца назад

Good morning, I have exactly the same problem with a Yaesu G1000DXC. Please tell us the solution when you have it repaired.

@DarrenN4VFR 2 месяца назад

Well, Yaesu told me nothing was wrong with my G2800 and said it could be my Controller. Next time I get back home for a few days to troubleshoot it, I'll also make a video on what I did to troubleshoot. 73 de N4VFR

@JuanjoGameroLopez 2 месяца назад

@@DarrenN4VFR A few days ago I took the external rotor unit down from the tower. I have tested it at home with a new cable and it works perfectly. So my problem is the control cable, it must have some bad contact.

@DarrenN4VFR 2 месяца назад

@@JuanjoGameroLopez Thank you. I might have to do that too. But first, I will check the voltages on the controller to make sure it's 24vdc. I talked to the Yaesu Tech during Hamvention. Watch that video if you havent yet. 73