Yamaha MT09 2022 tank pads install

Подписаться 121

Просмотров 2,6 тыс.

50% 1

Installing tank pads on my 2022 Yamaha MT09.
First time in my life to do it :-)
The tank pads I have bought from Wish not Aliexpress as mentioned in the video. They are pretty ok but keep in mind that I have learned a lesson that I should have used a scissor to trim the edges.
I used for this video:
- Samsung Galaxy Note 9 with external mic
- Campark V30 action camera
PS! Please be advised that this video content is for information purposes only. Use at your own risk

Авто/Мото

Опубликовано:

28 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 8

@zuzu_swe Год назад

Great video thanks. How is the quality of these pads? Are they hard or soft as rubber? Thanks again

@swedrider Год назад

Happy that you liked my video! The quality is nice according to me. But you need to trim the edges as I said in the vid. They are made of rubber so pretty nice

@themystx2 Год назад

The glue on these pads are horrible. It’s a guarantee it will turn into a goopy mess the first day out in the summer, stick to tech spec!

@swedrider Год назад

I do agree about that. I have a friend who bought his from Yamaha and had also the same problem. I will see how they will perform this summer otherwise I will change to other. Will make a video on that then. Thanks for the visit and the tip and have fun!

@TheKez1a Год назад

@@swedriderHey, most tank pads reccomend heating both the pad and surface with a hair dryer or hot air gun to improve to quality if the glue bond and allowing the glue to cure for 24/48hrs. This will help prevent peeling in the future.

@swedrider Год назад

@@TheKez1a I agree with you. The reason I didn't do that was that these pads är cheap and I want to see how bad they can intract with the paint first then I will put new ones. That make it easier to change them to other ones. Thanks for your comment appreciate it! 🙂

@xxentonxx7483 Год назад

Yep the glue is horrible... Attached the tankpad on my new MT-09 and the glue is literally everywhere. In the manual was written, that you place it on the surface, press all the corners with 3kg pressure on the surface, wait about 24 minutes and then you can remove the rest of the glue from all around the pad. Well, there is my problem, because there are many little pieces left on the edges of the pad...

@swedrider Год назад

@@xxentonxx7483 Ya it is not easy to get rid of the glue on the edges. For me seems that the pads did shrink a bit and left the glue at the same size as before