Yamaha xs400 carburetor rebuild and theory

Подписаться 16

Просмотров 1,1 тыс.

50% 1

This video is for single overhead cam bikes mostly with within the years 1979 to 1982 before they switched over to dual overhead cam engines I go over the entire carburetor the best I can to keep the video as short as I can with out edit.

Опубликовано:

23 мар 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 12

@bc-mr1si 2 месяца назад

can you do a video on float adjustment 🤔

@edvinrosback7977 3 месяца назад

Good video man !

@theMADox89 25 дней назад

Great video with awesome explanations! While cleaning carburetors, I had lost that little ball in the choke rod assembly. Any idea how specific the size of that ball is?

@theMADox89 23 дня назад

Going through my tool box, I found the spring and ball. Now I realize I don't have the washer and O ring. How crucial are these?

@bc-mr1si 2 месяца назад

great video. wish you had posted this sooner.thx for sharing. how did you get the float needle housing out🤔.ive had mine out once had to clamp mole grips gently on to it and pull.is there an easier way 🤔

@kuvakustom_cycles7623 2 месяца назад

I use side cutters on the flare end. Just the leverage of the taper side of the cutters is enough to pull the shaft out to then use your fingers for the rest.

@bc-mr1si 2 месяца назад

@kuvakustom_cycles7623 thanks .what's side cutters 🤔

@kuvakustom_cycles7623 2 месяца назад

@@bc-mr1si Pliers used to normally cut wire

@bc-mr1si 2 месяца назад

@@kuvakustom_cycles7623 ah got u.ill take the carbs off again for god knows how many times😀👍

@doesnt_even_lift Месяц назад

I have an 81 XS200 special that I'm working on which came stock with mikuni carbs, but all the kits for these seem to specifically say 'not for 1981 XS200 with mikuni carbs' on them. Any ideas about how to get around this if I need new jets? I think the gaskets from some of the older kits will work

@kuvakustom_cycles7623 Месяц назад

You can resize jets with very small drill bits. (Best to measure the bits first before drilling) If you need to go a smaller size you can fill the jet with solder and drill the size you need. I highly recommend using a drill press and the needle jet to hold the jet as the drill bits can break easily and leave you in trouble if you get it stuck in the jet.