Thanks for the video, this was very useful. In my case I didn't have an ultrasound cleaner and the pins were really stuck in place so I had to drill a (very small) hole under the pins to push them out. I don't think the small hole will cause any problems, it's too small for the pin to fall through, and the putty will seal the whole thing anyway. Just mentioning it here in case this information is useful to anybody attempting this in the future.
use decompression leavers when starting is difficult. I use to turn over 2 when it is less than 5 deg celcius. Then it starts more easily, then I turn back the 2.
@@sailingfromsamsara9972 No i have never done that. I think for changing piston rings you should buy a repair kit with Liner Cylinder/Sleeve and pistons.
To disable one or two cylinders to make the motor spin easier during start. This is especially at low temperatures. Then you switch it in when motor starts.