If you like Datsun Z cars this is the channel for you. I am rebuilding a 1975 280z from the ground up with a 1JZ VVTI heart. This is the first car I have ever built so enjoy the learning experience with me and feel free to provide helpful feedback. It is the first car I've ever built but it won't be the last. I love cars and plan to do many restorations!
If you want to be a featured channel or work together to help each other grow. Comment on a video or send an email and we should be able to work something out.
😂 this comment hits deep. It’s still in the plans! I’ve got lots of equipment now to make it happen, so just need to prioritize it. Building my s13 is a goal for me and this is the first thing to do
The partible models that set on floor (1 hose) work way better for heating. Put out hot not warm air. Keeping compressor out of the cold and just blowing the cold air out is even more efficient than an actual heat pump. Plus they use standard 115 volt outlet. Most of the air they blow out is recirculated so they don't produce negative vacuum like most people claim. They work great for A/C too!
This helped. Just bought mine today to off some storage to convert my actual 3 car garage into an office and small gym. How did you configure your power you ran to the shed? Did you cut a hole or ran it through the vents?
Yes I bought a some 1.5in plastic conduit and cut a hole in the back wall to run the extension cord. I caulked around the pipe. I’m not using much load so extension cord was fine in my case.
2016 dodge van manual door with just the rear hatch being bad. This much work just to replace the latch is unreal. I can't get the latch to move at all from the outside, and door wont close all the way. What a pain.
what wheel spacers did you get do the fronts do they have to be 66.1mm ? cause on my zx cause of the front spindle part are a bit wider on the hub they dont sit flush do you need a 73mm center bore wheel spacer ?
Thank you for great review looks great 👏🏽 love the color of your house as well. Do you mind me asking what color did you use for the exterior? Thank you!
There just isnt any good method to install these without damaging the bearings😮. I wish these were rollerbearings, that way you would have some way to install them without transferring the forces through the balls. And also it would give you the chance to "service" them like changing grease and tightening as needed.
All of these methods are dangerous. Heating causes fumes that are harmful to your lungs. Wire wheeling produces dust, which is also harmful. It's best to go to Home Depot, buy Citristrip, brush it on, cover it with plastic, and wait a minimum of 24 hours (ideally 48 hours). The paint will come off easily, similar to peeling an orange.
