Do you think a lift Subaru outback wilderness could make it through that first half before it opens up? I've never have been there but been wanting to go.
you can see from the start of the video how rutted out some of the areas are. I dont know how an outback will do with limited ground clearance and wheel travel would do.
02 lexus ls430 with aftermarket audio system. Have 2 agm batteries. Bought the diode from orileys parts store for 5$ n voltage went from 13.6 to 14.2 at idle. Now my batteries getting charged properly. Have a volt meter so I can see my voltage
@@Wonger559 learned from your video and had to give it a try cause of my aftermarket audio system and running 2 agm batteries. Glad I did. Now my batteries will last me longer plus the amplifier is happy with the better voltage.
Hey brother. I have an 03 Tacoma resto project going on. Just painted it coyote Tan bedliner, new engine on the way. Previously put a TRD Elocker & truetrac front Diff in it along with a Northwest off-road trails custom front bumper. The Suspension has 5100 at stock setting with OME 0884 springs. The UCA are SPE with the adjustable upper ball joint set at max Negative caster. I’m curious how you like your Solo LCAs? The TC ball joint swap may be in my future as I already had a Moog “problem solver” break. May go with the Solo LCA when I do the swap.
They are a little noise but it was expected. I love them so far as it allowed me to upgrade to poly bushings. They also do offer a little more ground clearance and able to dial in more caster
Never torqued to 125ft.lbs. *Laughs in heavy equipment tech* Haha, great video man. I just had a lower ball joint fail after about 9 months and maybe 5,000 miles, considering this upgrade now. Don't trust jobber parts!
You did a great job. Thank you for all your work and video. I am getting ready to tackle this same job on my 2003 tundra next week. You gave some good pointers that will make my install run smooth.
I have been wanting to get the rest of the plates for my sequoia for a bit but I did buy the trans skid plate with the cat guards a few years back due to my cats being stolen while parked at work one day, supposedly secure lot with cameras but didn't get anything on it lol go figure. I did engrave a nice message on it before installing though, I'll message you over at Instagram with pics lol. Oh and I installed security torx button heads on the install to keep things secure.
@Wonger559 do you just keep it in the car? I've never dispersed camped/overlanded but I'm hoping to go soon, just wanna make sure I'm not attracting bears lol
Nice video and thanks for mentioning your experience with the caster. Did you have any trouble getting the cotter pin in the ball joint with this arm? Also, any trouble with the lack of steering stops?
Really nice video but, you need to work on balancing the sound. Had to turn way up to hear conversation then, be johnny on the spot to turn down when music came on. Nearly blew out a set of speakers.
Couldn’t you just take the chip out of your key and tape it to the side of the ignition switch and forget all that junk then any key cut correctly will work
Thanks for the reply! After I took things apart I found that the wires were spliced and not even properly, so I'm guessing the light is aftermarket. I found a work around tho. Love the channel!
@@Wonger559thank you sir! Can’t wait to explore around the area. I’ve seen on other videos that there’s a small waterfall there. Guess you guys didn’t make it there?
This is one of the most disgusting and disheartening videos I've seen in a while. I've heard about all the "overlander" crowds in area, but never really experienced it or seen it personally until this video. This area is being destroyed and will only be a matter of time before it's "limited or permit required use only" because of all these people. That area can't support all those people at one time, and was never intended to have that many people crammed into that area at one time. It saddens and disgusts me because I've been going to that area for over 25 years and never in my wildest dreams could I imagine that many people up there at once. You people don't even respect the area. You are required to have your camp be a minimum of 100' away from water sources, not only for potential pollution run-off, but more importantly to allow wildlife to access water sources too. I mean come on, you're right up against a wilderness area, although I'm sure almost everyone up there doesn't know that or could careless! Everyone up there is more worried about their instagram shots and showing off their overland gear than they are about the actual outdoor experience. It's not about getting in the wilderness anymore, it's all about the look at me and what I have bolted to my vehicle. Case in point, you go all that way to camp in an absolutely amazing area and you watch a movie. Must have been wonderful for all your neighbors, but looking at how everyone everyone else is adhering to the 100' setback, I'm sure you weren't the only movie watchers.
This is one of the most disgusting and disheartening videos I've seen in a while. I've heard about all the "overlander" crowds in area, but never really experienced it or seen it personally until this video. This area is being destroyed and will only be a matter of time before it's "limited or permit required use only" because of all these people. That area can't support all those people at one time, and was never intended to have that many people crammed into that area at one time. It saddens and disgusts me because I've been going to that area for over 25 years and never in my wildest dreams could I imagine that many people up there at once. You people don't even respect the area. You are required to have your camp be a minimum of 100' away from water sources, not only for potential pollution run-off, but more importantly to allow wildlife to access water sources too. I mean come on, you're right up against a wilderness area, although I'm sure almost everyone up there doesn't know that or could careless! Everyone up there is more worried about their instagram shots and showing off their overland gear than they are about the actual outdoor experience. It's not about getting in the wilderness anymore, it's all about the look at me and what I have bolted to my vehicle. Case in point, you go all that way to camp in an absolutely amazing area and you watch a movie. Must have been wonderful for all your neighbors, but looking at how everyone everyone else is adhering to the 100' setback, I'm sure you weren't the only movie watchers.
Hey, you have issues with your steering rack much? I had my steering rack go out and rebuilt it through solomotorsports. Then I went on a camping trip 12miles or so off road pretty bumpy but went slow and now I have play in my rack and inner tie rod has play too! It like my truck can’t handle rough roads, lol
No issues with my steering rack. I do have a brand new OEM rack and pinion and fairly new oem outer tie rod ends. If you watch my newest video. I was jumping and hauling on some pretty rough roads at 20 psi. I typically run 15psi or less but with as much miles we had to cover on dirt, it was a compromise to get some better mpg lol
@@Wonger559 thanks, probably should air down more…. Have you tried any quick disconnect links for sway bar? I seen redrunner makes some that look like they will work.
@@heismyrefuge1027 you get used to it after a week or so. the fox 2.5 with the compression turned up has helped with gaining about 50% of what the sway bar did before
Thanks for stopping to save my trailer. It was quite an ordeal for me on that trip. Jeep got hydro locked at the river, which eventually got towed out a week later. Trailer wheel falling off while rescuing it home with my secondary rig... Trailer axle replaced, engine on jeep replaced.
Yeah, that looks like all you need in a kit for one or two people. Now JetBoil will need to approach you for your design! One suggestion to save space -maybe even enough space to be able to carry a 1lb tank inside your kit - is to store the Luna and the pot support *inside* the cup. That's where I keep my Luna burner with my Genesis system. It's designed to do that.
Quick question for u? I added a pressure switch and it seems to work! however the compressor comes back on every 30 seconds or so for maybe 1 second. Is this normal? Or am I losing pressure somewhere? I thought once it reached the desired psi and was not in use it would stay off until I turned it on
nice set up. I use a half gen with the luna combo on trips when I cant use a backpacking stove. I wanted something i could make breakfast in the skillet while percolating coffee. For dinner I cook in the skillet while boiling potatoes/making soup at the same time.
On my 04 Access Cab, I have Fox 2.5 with remote resi ~12' travel shocks. For this 06 Double Cab, not sure yet or if he will even get them. Got a topper coming for it and wanted the option since I didnt want to take the topper and bed off to do it later lol
I spent many years in the 70s up there on dirt bikes.such a wonderful place.my dad rented an old cabin in kennedy meadows. For about 15 yrs.thanks for the video so many memories come flooding back
Is there a Part 1 to this video because the way it starts it seems like it just cuts in from some other video. No discussion or explanation beforehand. Also.. it looks entirely too small.
torque specs will vary depend on which bolts you use and what year your vehicle is. There is I believe 4 different torque specs. If you want torque specs, check out the upgrade ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-dE_LiLHPNNE.html
I'm looking to get that lbj conversion next year. Do you still recommend the solo Motorsports LCA? I'm factory upper/lower with 5100s but looking for a smoother ride offroad. Looking at ADS for front and rear shocks. How do you like your UCA? Thank you!
Solo arm is recommend if you plan to adjust your caster positive past oem specs and/or you LCA bushings are shot. UCA all are the same if you go with brand name uniball ones. Mine are camburg but I wouldn’t mind swapping to solo UCA to match brands lol
@@Wonger559 That makes sense, my lca's are still fairly new. Matching would look pretty sweet. Thanks bro I appreciate it. I look forward to future videos🤘🏻