I found the issue & fixed it today. So after further inspection on the differential a few things were noticed. The hardware holding the driveshaft to the front of the dif were not fastened tightly. Also the nut that holds on the pinion was loose. The assembly could be shook by hand in all angles. It leaked fluid from the seal too. Because I didn’t want to rebuild it I just hit the yard w a buddy and vin matched a rear end and swapped it. The truck drives so nice. No rubbing sound fixed. But I’d assume the differential pinion bearing is going out when this sound occurs
That's what I did it was a hell of a lot easier to go to the junk yard lol I replaced alot of parts on that truck whole drive train was practically new but found the cause on mine was the pinion in bearings and spider gear was shot even tho it sounded like it was coming from the transmission lol but junk yard saved the day
TTI makes hart tools and vacuums. As far as vacuums, they make oreck, Dirt Devil, and hoover. Hart uses hoover designs. Decent bang for your buck based on reliable proven designs.
I know these suburban/year/Silverado’s waaayyy too well I have a z71 mine was tranny and transfer case. However yours was moving pretty well so I figured the rear end was on the way out of chat. Hope all is well!
Thank u for watching the video and leaving a comment hope u have a great weekend! If You have any suggestions on new videos u would like me to do, let me happy to help!
Ive been very pleased with it. I'm a fuel pump technician. Swap alot of card readers, pinpad, computer boards and plastic mounted modules. It's a beauty for jobs like that
Bro I’m grabbing this vacuum today,wanted to look at reviews first. Saw this post and am glad I stubbles across this because I have never seen a skinny piece w a light. Cheers dude
Lol well the vacuum is still going strong and so is the attachment with the light if u have any suggestions on items u would like for me to review let me know I'm always up for viewers suggestions
That I have and it worked great for about 4months around 16 details and then motor started getting really loud but if needed I can make a video on the attachments I bought
@brianlopez8196 I finally got the newer one they dropped about little over 4months ago due to they were on sale for 70 lol both are still kicking strong!
Yes unless u have another person with u that can hold the bumper driver side out while u get to the bottom bolt that's covered if the bottom bolt plastic part is already broken u can go to the fender well remove the skirting and can get to it that way
Check your front differential fluid. also good to atleast jack up the passenger front wheel and see if u have any play alot of times your wheel bearing or cv axle will cause a whinning sound and come and go.
I’m not sure abt mine I have a 08 Silverado and makes pretty much the same noise. I thought I was my transfer case so I replaced it and I still have the same noise. I have a vid up on my channel I believe.
It was my rear end I went to the junk yard and got a used rear end and sound stop check your output bearing on the front of the dif rite where your drive shaft hooks up to
@@vibescold906 just figured it out. I have a cassis sound thing and I hooked it up to my rear diff and it’s LOUD. Ty imma look into a pick n pull place tomorrow to see what I can find.
I have Jeep Wrangler with black fabric seat with mild coffee stains, what do you recommend? I was going to go with Chemical Guys Citrus clean but expensive. What about going with natural dish soap instead? Cheers!