No one shows exactly how to tighten the top bolt it's not easy without the right tools!

Life saving money saving time saving video way to go my man you and your sister ❤

hi. Is it normal that when the engine is running and you remove the oil cap or oil dipstick the engine is sucking air. When I do that idle gets unstable and when i put them back on and everything is sealed the engine idle gets back to normal. thank you for sharing the video.

i'm reading "think and grow rich" and it boils down to having a burning desire to achieve your goals. I can relate to this video.. very powerful!

anyone know the size of that grommet

Can I hookup a reverse camera to a 2013 chevy malibu LT? It has a mylink

Canst stand this car

Thank you

Man, i have a Kia Sorento 2011 with the same problem. I just fixed it right now, after three months, with the help of your video! Thanks from Brazil =D

Thank you!!! Short, sweet and to the point! 🎊🥳🎉💛

Can’t wait to get out and fix my wife’s car, thanks!

Question do you have bleed the system after you replace pads?

same sensor for the front and back??

Best video where it's explained how do these wire clamps that hold pad guide pins.

Literally makes a video, and don't tell how to take out part that covers the first screws 😅

Lifesaver!!

Please can someone help me. I bought a new trunk latch, and went to replace it by following your video. But when I crawled into the trunk, the gray cover, along with all the clips, were missing. And the yellow release cord had been removed completely. The mechanics at the dealership have done this without telling me, because I had personally pulled the yellow cord to open the trunk before I took her into the shop to have that safety recall fixed. I have no idea why they did this, and they are refusing to admit that they did it. But now the thing is, I can't open the trunk to change the latch. Is there any other way to get the trunk latch to open without the yellow cord? 🥺

Man this is honestly the best one-handed video I've ever seen. Good stuff, man.

Thanks for taking the time to make this video! Just ran FORSCAN, tying to diagnose why my AC blows hot, and this code popped up!

Bro very very detail videos this video can help a car idiot get the job done it’s self I know it help me thanks ❤🎉😊

Nice job on the vid & instructions. I watched a different one in which the guy took the wheel off (though he said you didn't need too), then removed the wheel-well ABS to get to the socket. I said, "BS on that!"...I'm lookin for a different vid. And viola! I found yours. Thx!

Two years later you still bringing sanity back. Thank you!!

I would recommend using the Dorman replacement oil cooler, its aluminum not the cheap plastic part

Just spent 2 hours trying to get the drivers side out. Thanks bro I gave up because I have work in the morning so only the passenger side is completed but that was the real bad one anyway. Tomorrow after watching this video I’m going to knock out the drivers side. Pain in the ass man I thought the manufacturer did me dirty 😅

Waste of time

I changed both of those cam sensors and car still don’t starts only code i get is a coolant temperature sensor could it be that stoping my car?

What’s that box called ?

I got a 1000 car for 8,900 in a pay here house , in my ignorance I think was a good deal but I got scam with a broken high mileage junk yard car , so I take it the gps off and I move to other state , and that’s it , I just have a no title car on my garage and I using for parts

Does help me out thank you

How do you remove the motor from the tracks ? Please help

This is a continuous problem my wife car. My Ford F150 had continuous problems with cam phasers, very expensive repair. Stay away from Ford.

Does it matter if it's aftermarket or OEM part for the code to go away?

How do you turn it on after booking it up should I wait for a signal to start the car or should I leave it for couple seconds

I use a piece of rubber gas line to get them started back in,a 6 inch piece in hose as long as it fits tight around the end of the spark plug.

Extremely helpful. Thanks!!

This is NOT a 2015 car

2:38 - this is where I am struggling. It doesn't come out.

Keep up with regular maintenance and you won’t have problems like this.

Didnt it need to Re-Learn ???

It works guys thank you 👏🏾

Got mine close like this but now we try to fix it but no current is coming to the motors check the fuse and their are good what you think is the problem?

This just happen to my my 2014 ats thanks

Nice fix man, thank you, is either this or taking it to a dealer for them to do the same thing and charge $500.

My 14 S started making something similar and it's annoying the shit outta me at least I know now and fix it

I replaced it and it still leaks, nothing wrong with the cooler, just pools from underneath it, dk whats wrong with it, checked everything around it and nothing, keeps leaking oil slowly

Excellent Video and very well explained..Couldnt be better. Thanks!

THANK YOU!!!!!!!!!

Quick, easy, straight to the point. Thanks sir!

What is torgue on valve cover bolts.

just just cleaning it works a lot of times surprised you didn’t give that a shot