My boat has a M4 prop shaft, 35mm prop, 1100kV 3536 outrunner and a 45x35 rudder. It is a good stable, planing hull on 3S. I have the Atlantic boat which has the same planing hull and brushless drive as the Salina. An X35 prop makes it fly.
I'm a new subscriber. I built this out board motor but I threw in some brass gears. I have a video out with it on a small boat runs amazing thanks for sharing this.
hello mr I saw on the side hull it had holes do you put carbon cubes or not and you use how many reels of PLA for the complete printing and what glue do you use to assemble the parts and for stick the carbon fabric thank you cordially I await your return
@@Mr.RC-Creator Do you still have the files by any chance? I want to print this boat and your parts selection would fit my needs a lot more than the original ones. Thanks in advance!
hello I made the boat in 3d printing did I install a thermal engine in it there is no risk that the ceiling please thank you cordially I am waiting for your return
thank you for your advice is the pla it will melt with the heat of the thermal engine in a small question the carbon canvas you order it or and for the application I see you put resin is it possible to have the link for all that please thank you
question, i built this boat with the same motor you did but used a 90A water cooled esc. when i put it in water ans give it throttle the motor cuts out. Any thoughts? Thanks again!
