Sick wrangler mate! I have had the same wheel and tire, it was 33 5/8 not really that close to my liking. I now have the 39” bfg km3 and they are just a smij taller than 37”.
I STILL cant understand why there's NO front and rear protection, (just the sides) where you could easily drill into the console. Seems like a waste of money
Two Errors I see. First, you forgot to put the Fairlead on the front of the bumper during your installation. Second, you left your mistake in the video for others to repeat. It would be more helpful to others if you add in the correction during editing.
Have you ever had any problem unlocking the soft top? I tried installing my soft top today but couldn't because I couldn't unlock the drivers side:( The passenger side locks and unlocks fine but not the drivers side. Can't seem to find any information on how to fix it:(
Scott, that is a cb/ham radio microphone holder similar to this one. Areyourshop 75WXST Two Way Radio Holder Walkie Talkie Bracket for Wrangler JL 2018+ www.amazon.com/dp/B07KS6BK7C/ref=cm_sw_r_apan_i_NAPZBYX80P4CW9FR5A97
Thankyou Thankyou Thankyou, i took off the doors my my jeep and i got scared think the door check were stuck. I almost took it to the dealership so they could fix
How are these tires holding up? Likes and dislikes? I'm looking at getting the exact same tire for my black Methods to go on my 2020 JLUR as well. Glad you measured the tire also because I've heard that BFGs typically run smaller than others... Was the tire measurement to the top of outer tread block? Thanks!!
Cueto - I sold the Jeep in December but at that time, the tires had about 7k on them. They held up fine although did have a chunk or two removed due to off roading but nothing that impacted noise or ride quality. The measurement was to the top of the tread block. KM3 is a great choice if you are planning to off road a good deal.
@@marcmiller3753 that was actually my first choice then either the km3 or ridge grapplers....but my local shop hasn't seen ANY Baja Boss ATs available in the last 3 months! That's why leaning towards the km3 or RGs.
Can you connect ground to anywhere on the metal frame of the jeep to complete the circuit? Also, my winch just makes a clicking noise and no movement, what might that be?
I use the winch maybe .2% of the time I use the Jeep = very minimally. The switch is left off in case there are issues with the wire rubbing on the Jeep and possibly breaking through the insulation and arcing, creating a fire hazard. Better safe than sorry.