02:48 This is a feature called DisplayPort Alternate Mode. You can input the video output from the graphic board to the motherboard and convert it to Thunderbolt4 output. Notice in the following scene that there is only one cable connected to the display (i.e. the video signal and power supply are on the same cable).
They have ability to contact manufacturers to make many things on spot for good prices. Make it very easy for small businesses to turn ideas into products in short time, without much overhead investment.
Ever heard of ram clearance? Which on an itx motherboard is even more important. Out of all the things you could have said about the video, you just had to hate. Nothing about anything else.
Nice case, but acoustically an absolute nightmare. A tiny fan on the motherboard, another one in the PSU (sucking hot air from within the case), and another one mounted as case fan. Then there’s a single fan GPU and low profile fans that also have to spin up quite a bit to move any meaningful amount of air. It would be nice if this case should be little bit bigger, to offer SFX PSU support and better cooling options.
i have had the osmi 3.O, built the sixge k2s and the cooj mq5 and the worst in terms of thermals is the k2s because i got the better ventilation pane of the cooj... the osmi has the advantage of the large 120mm fans pulling from the bottom but its loud when it kicks in... i would give cooj alot of kudos for such a nice design that caters to some of us who dont want a gigantic case of a showrom, but petit enough to pack a punch reasonably too.
nice looking itx case imo i rather get a mini pc like ser6 than build a itx pc if i want performance, i would have go for micro atx or atx build instead
It collects dust and pet hairs. It also gets very hot inside and toasts thermal paste very quicklyl. Then replace thermal paste and clean fan means I need to disassemble almost everything. And it is not fun at all to disassmble such a small thing.@@mehmetonurlu
Блин, как же мне нравится этот корпус, да вот жаль, что ни блок питания SFX и полное жидкостное охлаждение поставить, так как просто места нет. Вот был бы по больше, да даже на 1,5 литра, купил бы не задумываясь.
На видео не такой уж и маленький копрус. Если взять какой нидуь NR200P туда и воду поставить можно и SFX БП и любое топ железо, а объем литров 18 всего
CPU clearance is 72mm, should have used a NH-L12S instead, the noise and temp would have had a significant improvement. But then again, just for an extra 2cm of width, should have used Ncase M1, with much better temps.
as far as i know, it's to run the monitor on a single thunderbolt cable (vs hdmi/dp + power cable) the displayport (from gpu) to motherboard usbc acts as passthrough then he runs a single cable from motherboard to monitor, thunderbolt 4 supports up to 100w so i think whatever motherboard he has apparently supports that, or at least enough wattage for a monitor
Definitely the move over intel, amd sips power. I’m getting basically stock scores max power draw 60watts on 7600 using pbo+undervolt. Max 85 degrees in the Dan A4-H2O with wraith stealth cooler
2:46 What are the screws that she’s putting onto the WiFi/Bt posts? I’m assuming that they’re “blanks” meant to just cover/protect the posts when not in use? If anyone could tell me the model number or manufacturer of those things I’d really appreciate it.
