Тёмный

1) Hangkai 18hp diy upgrade to increase power and lifespan 2)diy the Best water pump system for IB 

DIY Chong
Подписаться 517
Просмотров 13 тыс.
50% 1

Опубликовано:

 

28 окт 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 61   
@leonwong3631
@leonwong3631 2 года назад
Thank you for sharing bro , I'm planning to buy a Hangkai 12 hp for my 11 feet aluminium Jon boat 👍🏻😘🤩
@barrylusich3712
@barrylusich3712 2 года назад
I made the power adjustment. My 15hp is the exact same as the 18hp under the hood. I will also install a hydro foil. I'm following all of your advice as well as the clear coat and anodes. Thank you so much!
@chong7091
@chong7091 2 года назад
Ya, hangkai 18hp is same as hangkai 9.9/15hp in different country. Because of my hangkai 15/18hp is still new and tight internal, i havent tune the ignition timing yet, with the original prop and at its factory full throttle setting, the factory timing( which is advanced) is ok, if one has adjusted the real power, the timing might need to set again otherwise the max rpm is over the factory recommendation which is 4500-5500. But if your boat is heavier or bigger, with the small factory prop with full power adjustment, if the rpm at full speed is around 5500 , you dont have to tune anything else then. I am not a marine expert but i know some car tuning only. I will update video after i test my new prop.
@LightSkinCapabilities
@LightSkinCapabilities 10 месяцев назад
@@chong7091 what other motors matche the hangkai 12hp? What carburetor can I upgrade it with?
@chong7091
@chong7091 10 месяцев назад
@@LightSkinCapabilities hangkai12hp carb is the same as tohatsu 9.8hp 2 stroke or patsun 9.8hp or hidea 9.8hp
@LightSkinCapabilities
@LightSkinCapabilities 10 месяцев назад
ok so if the tohatsu 9.8 can be upgraded to 15hp, does that mean I can use 15hp carburetor in the 12hp? @@chong7091
@alanhaas8056
@alanhaas8056 2 года назад
fantastic video I just bought one from walmart online Its winter here in ohio havent used it yet but will soon its the only two stroke i could get here in usa i will be mounting on 12 foot aluminum boat will give update top speed acceleration etc. next month thanks
@chong7091
@chong7091 2 года назад
12foot aluminium boat with hangkai 18hp....sweet! I am sure your boat can get over 20knot .
@ct1762
@ct1762 11 месяцев назад
yes the throttle butterfly needs to be exactly parallel just like any carbed outboard. the issue is you need to be careful its not going PAST fully parallel. take the air silencer cover off to be sure is good practice. throttle on tiller means nothing.
@chong7091
@chong7091 11 месяцев назад
Thanks for the sharing💋
@FishingAd
@FishingAd 2 года назад
Excellent setup 👌 👍 👏
@koalajs
@koalajs Год назад
Love it :) so many great ideas :) Did you manufacture the outboard trolley your self ? Looks like it allows sliding in and out the boot of your car with those extra 2 wheels at the top which is also detachable ? Great design
@chong7091
@chong7091 Год назад
Yes, i make the trolley myself. My trolley making video is in my channel, the handle bar of the wheels is detachable. Pls go in to my channel and watch 2 of my trolley video ya
@mvboutdoors
@mvboutdoors Год назад
Did the throttle arm adjustment help at all? Did you try before and after?
@chong7091
@chong7091 Год назад
Do you mean adjust the throttle for the carb to 100%open?. After adjust the throttle to 100%, using original hangkai prop , the rpm increase 200, about 5700... Which is too much. So if you just using the original prop, dont adjust the throttle. With higher pitch prop , adjust the throttle will help
@tlife3965
@tlife3965 6 месяцев назад
What size prop and pitch did you upgrade to and how many splines plz. And thank you for the Good video and information
@chong7091
@chong7091 6 месяцев назад
I have pitch 9, 10 and 11. For pitch 9 , i use it when there is a passenger in my ib boat. Pitch 10 and 11 when i boating alone, i like pitch 10 now because this day my boat and all the equipments are heavy.
@chong7091
@chong7091 6 месяцев назад
The hangkai 18hp prop is exactly same as yamaha 2 stroke and 4 stroke prop. The spline is 8 ....if i am not wrong
@mikeb2480
@mikeb2480 Год назад
Hello, where did you get the hydrofoil? Thanks for sharing.
@chong7091
@chong7091 Год назад
I make it myself. There is a diy video on my channel
@TheMak3itreign
@TheMak3itreign 4 месяца назад
You need to order bilge pump.
@crateandbarrels
@crateandbarrels 2 года назад
Great video. question about your bilge pump set up. you have to turn it on manually rather than it having a float switch right? also how much money in your currency was the 18hp outboard? they are $1700 Usd here but I would be curious how much they are across the world.
@chong7091
@chong7091 2 года назад
About the pump, you have to switch it on(i did diy an on off switch for the pump) when you need it or just plug in the pump connector to your power source. As for the hangkai18hp, its rm4500 with is about/less then usd1100 in malaysia.
@crateandbarrels
@crateandbarrels 2 года назад
@@chong7091 thank you. you can buy these in the US on ebay so i bet if you keep producing videos on this motor people like me looking for an outboard will watch them. does your boat do ok in rough water?
@chong7091
@chong7091 2 года назад
I just upload a video of me speeding at the sea this afternoon. My boat handle the wave well ........but it will be very bumpy ride.
@永康劳
@永康劳 Год назад
hangkai18hp sells the cheapest engine in China for $600
@borneo_trekker4923
@borneo_trekker4923 Год назад
Hi, i recently bought a hangkai 18hp too. May i know where you bought that tacho meter thing? Thks. Btw im from kuching too
@chong7091
@chong7091 Год назад
The rpm meter, i bought it from lazada /shopee, just type rpm meter
@borneo_trekker4923
@borneo_trekker4923 Год назад
@@chong7091 Thank you. Perhaps we can meet up some day.. im new to owning ib and engine so lots to learn from you
@chong7091
@chong7091 Год назад
Add me fb, clement chong prodyno
@iMaden_id
@iMaden_id Год назад
hallo brother DiY Chong .. salam dari jakarta .. :) boleh tak kami minta gamba rancang tempat mesin Hangkai awak .. kami nak contoh awak troly mesin tu. salam.
@chong7091
@chong7091 Год назад
Bro, saya tak ada gambar rancangan untuk trolley. Dalam youtube saya ada video untuk diy trolley saya.
@chong7091
@chong7091 Год назад
Gambar rancangan semua dalam otak sahaja😅
@topikdg
@topikdg Год назад
Morning sir..i need a tutorial for that outboard trolley sirrr
@chong7091
@chong7091 Год назад
Bro, i have 2 videos in my channel where i made the trolley from scrap.
@IjanHaisah
@IjanHaisah 5 месяцев назад
Bang nak tanya,dekat kaki enjin tu mcam ada tapak itik,itu gunanya untuk apa bang??
@chong7091
@chong7091 5 месяцев назад
Itu hydrofoil yang saya diy sendiri, saya ada video diy hydrofoil dalam channel saya. Ini fungsi hydrofoil boleh menolong boat "plane" ,tambah stability.
@thecahngcut0244
@thecahngcut0244 2 года назад
Bang aku baru aja beli enjin hangkai.18pk Saya mau tanya sedikit.apakah peporama hangkai 18pk ini,se banding dengan 15pk Yamaha.
@chong7091
@chong7091 2 года назад
Propeller hangkai18hp adalah 9 1/4 x 9 , yamaha 15hp propeller 9 1/4 X 11.
@thecahngcut0244
@thecahngcut0244 2 года назад
@@chong7091 Jadi harus kah aku ganti propeller Yamaha bang.
@chong7091
@chong7091 2 года назад
@@thecahngcut0244 yamaha 15hp propeller kasih boat laju 35kmh, hangkai 18hp 9 1/4 x 9 speed 30kmh tetapi pickup bagus dan kuat untuk boat berat.
@thecahngcut0244
@thecahngcut0244 2 года назад
@@chong7091 Bang saya sering x lihat Vidio Abang di RU-vid.selama pemakaian enjin hangkai ada masalah enggak dengan enjin nya.
@chong7091
@chong7091 2 года назад
@@thecahngcut0244 enjin tak ada masalah. Hanya Cat saja kopek di berapa tempat.
@flyinphil42
@flyinphil42 2 года назад
What is the purpose of adding the anodes for salt water Use?
@chong7091
@chong7091 2 года назад
It is becaus the hangkai anode is made for freshwater hence if one use the outboard in saltwater with the factory anode, the hangkai body will get oxidation very fast and then the factory paint will peel off . Changing the factory anode to original yamaha anode will slow down the oxidation process. 😁
@anasrafiq9164
@anasrafiq9164 Год назад
Macam mna nak setting trotel tu bos
@chong7091
@chong7091 Год назад
Itu trotel setting kena potong sedikit getah di tempat grip rubber. Kalao guna propeller standard hangkai 18hp ,jangan adjust kerana takut rpm enjin pusing terlalu tinggi. Kalao lepas adjust pun speed maximum tambah 2kmh je bagi standard kipas tu.
@anasrafiq9164
@anasrafiq9164 Год назад
@@chong7091 ada vedio x..kurang faham..fist time guna...😅😅...next tukar propeller baru nak setting....
@anasrafiq9164
@anasrafiq9164 Год назад
Sy sudah tukar kipas...mcm mna mau setting trotel bg full... hehehe
@chong7091
@chong7091 Год назад
@@anasrafiq9164 nanti senang saya buat video whatapps kamu. Saya raya original propeller lebih bagus untuk boat berat bapa kamu, dia dah lumba di sungai kah?
@anasrafiq9164
@anasrafiq9164 Год назад
Body 14 kaki sungai.....
@hirwanbinismail4916
@hirwanbinismail4916 2 года назад
Mana nak dapat gasket hankai 12 hp bos
@chong7091
@chong7091 2 года назад
Cuba cari di shopee atau lazada kalao nak gasket original hangkai yang murah. Tetapi kamu boleh beli yang tohatsu 9.8 punya gasket juga, pasti ada di kedai dan shopee lazada , tak berapa mahal juga .
@chong7091
@chong7091 2 года назад
Hangkai12hp part boleh ganti tohatsu 9.8, hangkai 18hp boleh guna yamaha 15hp
Далее
This is how Halo felt as a kid 🤣 (phelan.davies)
00:14
I Bought an $800 Knockoff Yamaha Outboard from Alibaba!
16:29
Why I NEVER Flush My Outboard!
15:09
Просмотров 988 тыс.
CHEAP Hangkai 18hp problem again!
8:34
Просмотров 5 тыс.
Hangkai 18hp outboard motor unboxing and startup!
8:03
Running a 200 HP outboard on small 14 ft Jon Boat
10:40