1500w JoJo VSD Pump Review

Подписаться 29 тыс.

Просмотров 11 тыс.

50% 1

We built our own rig to review manufacturers' claims on pumps.
We test the power consumption, and pressure at various flow rates.
This is the pump we reviewed in this video:
JoJo’s 1.5kW VSD Pump was specifically designed for larger homes and gardens, supplying between 1 and 6 bar pressure with a flow range of 5 to 108 liters per minute. It is ideal to use with solar systems, as it has a soft start and the speed at which the pump runs varies according to the pressure requirements, ensuring that minimal energy is being used.
Product Benefits:
Low noise level
Uses up to 80% less energy
Ideal for solar systems
Constant pressure supply
Easy to operate
Automatic start/stop function
Dry-running protection
Overcurrent protection
Motor power of 1.5kW
1 to 6 bar pressure
5 to 108 l/min flow
Pre-wired with 3-point plug
filtershop.co....

Опубликовано:

2 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 21

@sookmadiq6875 Год назад

thank you for the review, It would be great if you could also test the 0.75kw version of this pump to compare the performance.

@gysbertvanderwesthuizen8011 Год назад

Thanks bud, for making south African videos, for our conditions. I noticed that your input pipe from the storage tank, is pretty small. What is the rule around this? Im busy setting up a 1.1 KW Seakoo pump, with a 24liter pressure tank, and a pressure control switch. The input on the impeller is 1.25 inch, can I reduce the size from my tank to 1"? Also, the pressure control switch is set to start at 4 Bar. What should the bladder pressure in the pressure tank be? Thanks again. After this, Ill come chat to you about a filter system, Im close to Centurion.

@FilterShopZa Год назад

Basically you just don't want a situation where the pump pulls a vacuum and get cavitation as it will damage the pump. We ran a 25mm pipe with lots of bends but didn't have any issues on any of the pumps. It is meant to be a non ideal situation. With your setup you want to check at what pressure the pump turns on. Then set the pressure on your tank when empty to about 0.2bar lower than that pressure point. On the 1" pipe, I am running my house on a 1.5kw pump and have about 2m and 6 bends from my tank to the pump and it works well.

@tatendafmudadi3716 20 дней назад

Hi nice video, where can I get new pc board mine is blown

@FilterShopZa 19 дней назад

As it is a variable speed drive pump the board is quite expensive but email us at admin@filtershop.co.za then we can get you a price.

@kdc-nb5fw 4 месяца назад

Rubbish! Ours worked for a year. Costs more than a regular pump to replace motherboard. Don't buy it!

@FilterShopZa 3 месяца назад

What happened to the motherboard? It would be good for us to know

@tatendafmudadi3716 20 дней назад

Where do l get the pc board

@peterwest1513 4 месяца назад

Great video. Would the Jojo pump be no good if my ph was 6.1? The water only gets treated after its gone through thr booster pump. Thanks!

@FilterShopZa 4 месяца назад

Hi, no it would corrode away quite quickly, rather have a look at one of the HMS pumps. We have reviews on them too.

@capebee4839 Год назад

I would redo the test, but unwind the extention lead completely The lead wound up like that is acting like a coil It will reduce the power to the pump Pump will draw more amps and have a reduced power Very important not to leave the extention lead coiled

@andrewvanzyl1935 7 месяцев назад

The 0.75kW struggles to switch off so it churns away at low speed all day - even if I close the delivery valve. This after turning the pressure down to 3bar. It's been back to JoJo and is going back again. Very disappointed - it was an expensive piece of kit

@FilterShopZa 7 месяцев назад

That sounds like a faulty non-return valve. If you have corrosive water it could be rust from the pump that is making it not seal. I would disconnect it and see if you can clean the valve, it might solve the issue. Here is that pumps review if you want to see how it normally behaves: ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE--GL9Kt0NFJg.html

@andrewvanzyl1935 7 месяцев назад

@@FilterShopZa Many thanks. Pump replaced by Chamberlains. Great service

@FilterShopZa 7 месяцев назад

@@andrewvanzyl1935 Glad you got it sorted

@lenkiatleong 7 месяцев назад

May i know what is the size, brand and model of the 3 shower heads that can deliver 840 lph each at 2 bar as shown at 6:55 min? Amazing.

@FilterShopZa 7 месяцев назад

Hi, Yes this was one of our first tests and we changed the shower heads for later tests as they were very high flow. It was a relatively in expensive shower head from the hardware store but i cant remember the brand as it was years ago.

@lenkiatleong 7 месяцев назад

@@FilterShopZa Ok, thanks.