1991 Ford F250 Water Pump, Thermostat, Fan Clutch Change 

Thanks for the video ! To anyone doing this job, be careful at the spot around min 14 (AC power steering bracket) those bolts that pass thru on the right side of the pump. I broke off the lower portion of the bracket and I’ve seen others do the same.

yep, after watching this video. I successfully broke two bolts off in the engine. A bolt that goes through the timing cover, and the bolt that needs the P/S and A/C bracket moved. Fortunately for me, I watched McGyver on television, and got the truck back together. Fun Times replacing a water pump

You got more patience than I do I wouldn’t even attempt that with out small breaker or at least some sockets wrenchs

Looks like a great deal of fun..can't wait!

Super helpful video, "just break your fan shroud and rip it out".

lolol the ass whooping you're getting about 13:20 had me laughing

Somebody get this guy an impact.

awesome video man. Thanks a lot for showing how you did this project.

A socket and a breaker bar would've helped tremendously. That's how I got my bolts out.

like this guy..cursing..special ford tools(hammer and 2x4) ect. skechy unfamiliar parts..antifreeze on the ground for rover to lap up..just a normal guy getting by

Very entertaining video taking off that bolt with "the right tools"

I'm doing this to my e150 5.8l conversion this weekend. I'm going to try to wedge a 1/2" pry bar by the fan shaft to hold clutch in place while I brake bolts loose. The more I think about it, probably best to rent the tool.

Dude.............Hilarous,

It's an old video, but damn, the comments have me rolling I drained the old coolant out before I started taking things apart. Radiator has a drain plug lol

Double wrench method gives us more leverage to break a bolt out.

Love it when the wrench hits the ground, don't you? What a pain

It says in the video when you're done with the install do not fill with water only I was wondering why ?

the important thing, is not to get mad at it.

They do the fan like that so you can work in between the fins

I hope you turned the thermostat around before you installed it.

Can anyone tell me wear the sensor is for that my gauge doesn't show the temp and I want to check the sensor

nooooooooooooooooooooooooooooo

He doesn't have a clue

hmm...kinda sketch...lol good luck with your "doohickey"....

Some people are great at teaching others how not to do things.

Annoying video...