2003 Ford F350 6.0 Powerstroke Crank No Start / IPR Replacement 

Thank you

This truck came in and had an extremely slow crank. I put the ground on to eliminate a bad ground but mostly because I didn't want to roll around in the snow to look into the factory grounds. I left it because it fixed the slow cranking issue

👍

Check out what % the ipr is at and what pressure the icp sensor is reading. Does it make base oil pressure

Sounds like a bad wire connection of some sort. See if anything is loose at the battery or the solenoid

When your trying to take it off or putting it back on? I had that happen the first time going back in and I had to take it out and thread it back in again till it sat at a different position

I did just to gain more room but you may be able to get away with leaving it

An ipr socket. I forget where from

It must be a 35mm socket. But need to have a cut on the side for the connector.

Yup I forget what mm but you can take any deep socket and cut a piece out for the connector. Or for the 7.3 iprs where you can separate the electrical you can use a deep socket then out the wires on after