Hey folks, This video is a tutorial for the removal of the stranded A-arm protector and install of new OEM upgraded set for my 2021 Yamaha Grizzly 700, along with an ice cold beer and a bit of bad humor.
Thanks for the video! My XTR will be coming in March so I'm left to watch videos until it's here. One strong suggesting is to remove each bolt and use some anti seize on them. That was strongly recommended to me when I did the Skid Plates on my LTZ400. That area under the quad always being wet and dirty, makes it a good idea.
Hi there thanks for the comment and tip. I will do that for sure 👍.. yes it's always painful waiting for a new ride to come in. Your XTR is a very sharp 👌 looking side by side.. im sure you're going to really like it
Hi there. Yeah I can do one in the future of my light bar install for sure.. and no I actually spliced into the high beam in my wiring harness as I didn't want to be trying to find a separate switch all the time. Thanks for the comment.
Hi Leroy. No I haven't seen them.. But I'm running a set of their armored floor board skid plates and so far I'm impressed..check out my video of the installation. Thanks for the comment