#33 Lg front load water pump replacement 

It turns out this is the exact same model as mine so it's an extra great video for some details that I didn't notice when disassembling! Thanks.

Thank you! There are many videos demonstrating how to do this with minor differences by model. I have the same exact model with the 3 bolts holding the pump/housing in. Thank you for also showing the pump wire connections. I hastily removed the connections without noting their position. None of the other videos show the connections. Now I’m just waiting on my pump to arrive to swap it in. Thanks again!

I have this same unit and today I replaced the drain pump in about 20 minutes. This video helped but I will add a few things: 1- You do not have to remove the top. Remove only the front panel of the coin catcher and then tilt the machine back to get to the 3 10mm bolts that hold the pump assembly to the bottom plastic frame. 2- You do not have to remove any of the hoses from the pump body. After removing the 3 10mm bolts, pull the pump assembly to where you can remove the 3 screws that hold the pump assembly to the metal frame. Then remove the screw that holds the cover over the drain motor, unplug it, then remove the 2 remaining screw of the drain motor. **Make sure you pay attention to the orientation of the drain motor as it connects to the pump assembly. Then simply reverse the order of everything you did.

My LG stopped draining during the cycle and UE or OE errors. Going to try a new water pump. Great video!

You only took the top off but what else did you take apart to get to clearly work on the bottom where the pump is? You didn’t show the whole process.

Do you remember what model LG washer that is in the video? It looks like mine, which is a WM3670HVA. Other RU-vid videos showing the same drain pump replacement for this model washer approach the repair work differently. They want to gain access to take out the pump by removing the front door, which in turn requires unscrewing the control panel so as to fold it back to access to get to the screws to remove the door, and then to get access to pulling out the control panel, the top of the washer is taken off. Doing all this gave access to the drain pump for removal from the front. The method in these videos seem straight forward. They only complain of the difficulty of getting the wire spring back around the rubber door seal. Is the technique you show in your video the common one used to replace the pump? I fear putting down the heavy machine on its front could damage the control panel and/or door. Another question. Why is it necessary to disconnect the water hoses from the machine? Why could they not be disconnected at the faucets and let hang? Thank you for any response.

Why take the top off to just tipped it over to get to ot

I have the same washing machine.. Where can I buy a pump for it in Canada

Why did you take the top off?