Working on my 06 blaster! This video is great! My blaster been sitting for over 4 years so my carb is deff in need of this service! Thanks Built To Run for the detailed video! ❤
I appreciate the video man. Was my first time rebuilding my blasters carb. Basically I did it step by step with ya. Lol Definitely got a new sub. Thanks
Nice video, just a couple things. Stock air screw setting is 1.5 turns out not 2.5 There is also an air jet in the top of the venturi when looking at it from the air filter side. It's similar to the pilot jet and worth taking out to make sure it's clean. Also the jets are brass, not bronze. You should also verify proper float height while it's apart.
That was the Tori’s stuff it’s basically a safe thing that tend to cause lots of problems down the road. So I just delete it. Please like and subscribe.
You might have to clean out the carburetor the float might be stuck also make sure you have spark and a clean air filter and some fresh gas and a good new spark plug.
Hey man I have an 03 blaster 200 bought it off a guy who says it has a top end rebuild kit I have only road it down the road and back and it seems every gear right before the powerband kicks in it cuts out wants to shut off unless I pump the throttle. Any ideas on this? I’ve took the carb off cleaned it also did an oil injection blockage kit so I could pre mix my gas it still keeps bogging out right before the powerband and when it does kick it it’ll just wanna shut off can’t seem to find the problem
That unit that attaches to the carb on top, the tors unit. It has a big screw on top of it that you can adjust. How far in or out should it be? I see it can turn waaaay in or waaaay out and it changes the length of the throttle or something?
is this The stock carb? just bought a blaster with a fmf pipe and a carb like this. Having a problem whenever i start the bike it revs really high and then when i kill the bike gas comes out the overflow. I think it is the float needle because when i took it apart before it was already warn. Ordered a new one hopefully it fixes it.
Hi! I am wondering what the little clip is called that holds the throttle cable in place where the spring seats down in?? If you could let me know I would really appreciate it!
Hey man nice video! Do you know what that thing is that you screw the main jet into? I’m having trouble tracking one down. As you state in the video they don’t come in carb rebuild kits. I bought new jets for my blaster and on they won’t screw into that piece because the new jets have a bit bigger threading. The jet that was in there when I got it was a cheap Chinese jet. Thank you!
Works best when you use needle nose pliers, pinch on the cable and compress the spring and now you have more cable length and now it’s easier To install the metal clip.
Ah okay, so the stock carburetor should be a Mikuni (I was looking for confirmation). I recently bought an 01 Blaster with a mystery, no-name carb on it. The jets aren't labeled with sizes. Do your OEM jets have size numbers on them?
D.G D.G: The reason why I cut the wires is because it creates a problem it’s more of a safety feature for kids and stuff later down the road they can cause problems from not starting it’s just a safety thing for not to over rev.
i have a yamaha blaster, was unused during many years, i was trying to turn on i clean the carburator but it seems like i miss some hoses, can you load a picture of how and from where to where are coneccted all the hoses ( i can see just three ), i can share with you my email. thanks
Tengo un Blaster 200cc 2007 El problema es que aceleró y este no revoluciona, en baja se queda bien, cómo en el vídeo pero no acelera nada. alguien sabrá que puede ser? ya limpie el carburador y probé otro es 2007 help help
