Nice one. Loads of issues with condense pipes lately. Seems like the condensate dissolves the solvent weld over time, or causes the plastic to crack, fittings to fall apart etc. Not sure what the solution is.
Hi there, I am looking to become a gas engineer as well. What advice would you give me? Also what is the best way to get started in this field? Any help will be highly appreciated!
@@cputilitysolutions Thanks. What I mean parallel female ( flat face) to tamper female, not tamper female to tamper female. I can not find any merchant sell except all TF to TF. the point is it should be flat face inside back of the parallel female thread, sealing with the washer contact with the hob male connector rather than using compound or PTFE with TF thread.
I think that fitting came with the hob, its got a plastic cover on it. A typical female fitting with ptfe tape etc couldn't be used in this situation, it has to have a flat face at the bottom for a washer.