A Mud Pit Method for Reconditioning , Boring and Honing of 3 Cylinder Engine Block 

It's all about heat control when working on cast iron. Mud pit is simply to hold the heat and control the cooling. These guys might look primitive, but this kind of work is actually quite technical, and most welding and fabrication shops in the first world won't even touch this kind of repair due to the difficulty and risk of cracking the casting.

Они точно в постапокалипсис не пропадут и дадут всем фору. По сути они уже всю жизнь в приближенных к нему условиях оживляют машины и механизмы. Так что для них врятли сильно что-то поменяется, ну разве что они смогут обновить свои станки нахаляву. Честно, не перестают удивлять. Правильно говорят, кто хочет, тот ищет возможности.

Да ребята не парятся. Колено зажимает, проблема решаема! Просто отпустить болт на крайнем бугеле.

Why is there trash everywhere? Despite, they did an amazing job. Respect!

Если им дать современные технологии, они ракеты за неделю собирать будут 😂

They sure do a lot of those Massey tractor threes.

It’s archaic, but they get it done in the end

Cars will still be running there for quite some time after the apocalypse.

What was the problem with the original bolt holes that such drastic rework was required?

Very skilled. Where is this?

interesting dish to the pistons

@32:01 they didnt put any sealing rings on those pistons & yu could see there were provisions for thm

j'aimerai tellement savoir faire tous ça ..

Cool work thanks 👍

The warranty on those engines. 10 minutes or until it makes it off the property

I think growing your own garden variety engine, is good for you. No chemicals, just charcoal...plus the barbecuing of engines brings the family together. ...ashes to ashes, hyundais to hyundais...

Мотор собранный в таких условиях долго не работает

Ummm... piston rings?

Ещё походит)

How much does a job like this cost?

This Almost seems like Insanity ? A 3 cylinder Engine that gets 100 hours ? of Attention ? Most loving Relationships do not get that even in One month 😄🖤

I guess there is no such thing as deck height spec. !!

Tell me, what do you use as solder and flux?

Bonjour combien gagner vous d argent par jour?

Работа интересная, суетная. Но бесполезная. Из всех инструментов, был микрометр и тот не особо использовался... По сути, не долго ему поработать, потом обратно.

Short term fix. It will crack again.

*This must be an expensive job, they're using charcoal instead of cattle poo.* 💩💩💩

The boring and deck resurfacing is great......you can measure the imperfections with a Stanley tape measure. I have scrapped better equipment than being used in the video !!!!!!!!!!!! LOL

Bhai jan ap ka number ky ha