Добрый день , вчера приобрела кофемашинку Philips EP2220/10 . Все по инструкции собирала , настраивала , ваши видео тоже помогли мне. Сделала кружек 5 кофе . У меня там где должны быть шайбы с использованным кофе - много выды , а кофе лежит на дне
Добрый. Попробуйте установить крепость на максимум. И попоробуйте сделать регулировку помола - сначала мин возможный, сделайте 2 чашки. Проверьте. Если не помогло - сделайте помол на среднем значении. Подействует тоже со 2ой чашки. Крепость всегда держите максимальную.
@@OlegPC здравствуйте ещё раз . Делаю только на Макс крепкости но проблема осталась , вода в перемешку с кофе вместо шайб и там где должна быть только вода в ней тоже кофе . Это проблема ? Или ничего страшного ?
@@ТатьянаПономаренко-к7ч Немного воды останется после стартовой промывки и она сливается в лоток отходов - получается там «болото». Это норм. Другое дело - если вода сливается вместе с приготовлением кофе - это уже неисправность.
Hello. If question - how to replace ceramics burrs on Saeco grinders - than I got answer ))) To disattach burss - just turn them anti-clockwise on small degree (think about 10 degrees enough). Bottom burr will disattached easily, but for replace top one - you must clean 3 hols from up and down of Top burrs holder (in these holes - there is 3 ears of burrs, that holds it inside black ring with tooth)
Hi. I heard that adjustments should be made while the grinder is runnig. I didn’t know that and I turned the knob from finest to the mid point a few times. Is there a possibility that I damaged the grinder?
So basically you push it all the way to the end until the burrs touch? And then go back 3 clicks? How much is the extraction time now compared to before? I get 17 seconds now at finest knob setting
About tuning grinder - you are right. About extraction - such thing in automatic coffee machines is questionable - because you can extract any time that you want (just set new water level for button “espresso” or “americano” or any over. So 17 seconds can mean any cup volume, differ from grind size. My personal opinion - coffee machine can make about 70-100ml of nice coffee, other volumes are strange and not pleasant taste. Of course these numbers can vary from machine to machine
Hope you can help. I have a Saeco Spidem that is about 12 years old. We cleaned the gears and now the grind is very course. The "pucks" are watery and not well formed. This, of course, makes the coffee not the best and uses a lot of coffee beans. I have adjusted the grind to the finest using the knob while it was grinding and it did not make any difference. Please help!
Hello. Try to re-assemble grinder - something incorrect. Maybe top burr holder doesn’t fit inside ring-regulator with holes. Maybe these ring-regulator get some lift from one side (with time - it’s holding ears - wear out a little). So - just watch your grinder closely and try to understand - what’s wrong
@goterrapro5003 I have the same issue with my coffee grinder, after I cleaned the grinder even if I set the finest level the pucks are wet and not well formed. Did you finally solve this issue?
@@sebicarhat Wet coffee pack can be caused by many reasons - by brewing unit, by water connector 421946011491 (or over variations of these unit) ; by small coffee portion ( wrong program correction of grinder time) - will readjust correctly if other parts ( Brew unit, Water inlet, Brewing gears) will be renewed or repaired
This is ,usually, no problem. If you can find “just now” discarded coffeemaker - about 50% chance it will be or “ok” or need only clean, or chip repair needed. Biggest problem - find it before “garbage mafia” takes it. They sort “electronic” units and sell to the foreigners ( mostly from Ukraine, Belorussian, russian)
Доброго вечора! Разобрал кофемолку чтоб поменять мотор, но после замены она мелит слишком крупно. Пытался в ручную прокрутить верхний диск, даже когдо он закручен до упора, жернова не сопрекасаются. В чем может быть проблема?
Ни в чем. При затянутых жерновах - и правда есть зазор между жерновами. Они не касаются. А то что мелет крупно - наверно, ответ на «почему сгорел мотор» - что-то заклинило жернова ( при этом «побило» нарезку на них). Вот жернова и крупно мелят. Это если собрана кофемолка точно правильно.
Hi there again. may i know if this grinder adjustment works for my Philips automatic. i know it uses the same Saeco grinder but it does not require a screw key to turn the adjustments
Is there a way to adjust the amount of beans that the grinder grinds? Mine it only grinds for 3 seconds and seems like only 1/4 of the amount of coffee required for a shot. Coffee tastes watery and weak. Wondering if there is an adjustment on the grinder for a longer grind
We can only help machine to adjust more coffee grind time - but not to command such adjustment. So, first make full repair of brew unit ( hardly moving brew unit - advices to machine to grind less because it full of coffee (machine understand such)). Secondly - clear grinder inside and add new lubricant to moving metall parts of grinder. So our grinder can grind more because all it power will be send on grinding, but not on moving parts of grinder). Thirdly-to lubricant all plastic gears of brew unit motor
Hello thankyou for this video.. after making this adjustment, at what position should the knob adjuster be installed? Should it be installed so that once all the covers are installed, the dot is pointing to the smallest coffee bean size with no more fine adjustment - to prevent damage? Or is it OK to adjust a bit finer? OR is x3 gear teeth out maximum finest?
Hello. When you adjust grinder to closest grind stones position on doesn’t working grinder - always possible to regulate grinder even finer on working grinder. A think, after adjusting to most finer position, when you start your grinder (making cup of coffee) , you can make 3 clicks (approximately) finer grinds without damaging you grinder. Of course you must check yourself by hearing noise of working grinder - if you hears hard and slow work of motor - it signals that you at finest grind size position.
Thank you for the video man! is it possible for you to produce a video to show us how fine is the grind now? maybe can take a look at the coffee grounds after extraction - the puck
With this question - there is a difference between results of grinding from grinders with different work times (portions of coffee). So , in general, grind size must be much smaller than sugar particles. About 2-3 times.
Hello. It’s just simple action - just turn grind stones anti-clockwise (if I right). When you look closely to holder of bottom grind you will guess (by holes inside holder) that turn you need to do to release grind stone. This rule is acceptable to top grind stone holder.
