Saeco Vienna coffee grinder problem

Подписаться 3,7 тыс.

Просмотров 150 тыс.

50% 1

In this video you will see solution of following problem. :)
Problem:
It grinds but the grind does not stop after the normal time it keeps on going, I have to switch off to stop it.
Can you advise me what to look for when I take a look inside?
Solution:
It has two possibilities about this problem:
1. Clean the grinder burrs (conical)
2. Check the dose switch it can be damaged or not working properly.

Хобби

Опубликовано:

6 июн 2013

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 26

@RicardoMQA 9 лет назад

Thank you for sharing! Great video!!! I had this problem with the grinder and it helped me a lot.

@bigong2010 10 лет назад

I have the same ploblem as this. Thank very much. This video help me to fix it very easy. Thank so much.

@rachaelboards1 6 лет назад

Thank you, thank you, thank you for posting this!!! It fixed my issue.

@TomOuderits 7 лет назад

Thanks to your video I was able to repair my machine! Thank you x 1000!

@tuckeraxton9064 2 года назад

Instablaster...

@ugoeiras8366 9 лет назад

You are the best! Thank you

@azizikhodadad 10 лет назад

Nice! Thanx friend for the video and thorough explanations!

@auwz66 2 года назад

Thanks this video helped me out!! Cheers!!!

@alexwudowsummit8202 11 лет назад

@coffeecrazy2156 8 лет назад

Hello, I hope you are able to help me out with this. I decided to clean the screen on my Vienna Plus brew group and I took off the plastic tube that extended from the brew group. Upon re-assembly and putting everything back into place (including the o-rings, glass ball, and spring), I have run into quite a big problem that renders my machine useless. Whenever I run the brew cycle, the water and grinds pretty much just go straight into the case bin, without producing any espresso. I've ensured that everything is tightened including the screen which leads to me basically just give up on this because I can't figure out what the heck is wrong! It was working perfectly fine before I tried to open parts of the brew group to clean the screen.

@raducosma6757 Год назад

Not an expert but... It sounds like an O-ring is either missing or cracked, at the spout or the brew unit. Or a disconnected / broken hose.

@BRAVE_dj 2 года назад

I am trying to take the top off like this and it seemed to have another (a3rd) somewhere that block it from opening

@moonlight_and_voddka 8 лет назад

а если гриндер закручен до конца но помол все равно крпуный - в чем может быть проблема?

@marklaszl0 6 месяцев назад

I've got an interesting grinder problem for my Saeco. I have a video that I'd like to post or send you. Where can I email it?

@davidjohnson8596 9 лет назад

Hi Miroslav - When my Vienna plus grinder turns on there is a smell of burning electronics or plastic. Would you do a video or explain how to remove and inspect and test the grinder?

@didkoo7 8 лет назад

ффф

@ElectroLund 4 года назад

Hey! I had this exact same symptom with my Vienna. Took it to a local repair shop and $150 later, it was a bad thermostat.

@MrMile1954 9 лет назад

spasibo tovarishc

@rizab660 10 месяцев назад

My grinder dont stop grinding, it runs all time, where could be the problem?

@sharpdressed1799 Год назад

My Saeco Syntia grinder runs, but will only produce a cup of coffee every third or fourth try. Is the grinder worn out?

@moezmhamdi5219 Год назад

Did you fix the problem ?? If yes how did you do it ?

@sharpdressed1799 Год назад

@@moezmhamdi5219 Problem was not fixed. Took it to a repair shop. Paid $200. Still had problem not grinding, so we took it back to the repair shop. Will let you know what is done to repair it.

@moezmhamdi5219 Год назад

Are you using oily beans ?? I m trying this morning to drain the beans with paper and it is working properly

@sharpdressed1799 Год назад

@@moezmhamdi5219 No oily beans. Have tried a variety of different whole bean brands with no luck. Mine worked fine for a couple of years. Are you having a similar problems?