I kind of screwed up the pictures of the online places that carry these parts. Here is the specs: On the elbow, www.hydraulicstore.com # 1215375 6501-04-02 Female swivel jic/male pipe 90 degree 7/16 X 1/8” male pipe thread 1/4 fitting, www.fittingsandadapters.com Composite push to connect fittings 1/4” airline 1/8” female pipe thread
I actually used my angle grinder as I have become quite good at controlling it over the years. I put the air shock in my vice with the inlet pointing down and directly afterward set my smallest shop vac attachment on it. I have not had any problems to this point!
@@benhulburt4931 Thank you for the response yeah I’m actually probably going to push a small amount of Kleenex in the hole and use an angle grinder to take it off. Hate to have to take the shock off.
Hello! This link will bring you to a shock setup that will fit your link pin beetle front beam. www.dubparts.com/products/classic-vw-short-air-ride-shocks-for-type-1-link-pin-beetle-bug-ghia-1
I ordered some from Amazon but my threads on shock is standard adapter was metric are yours male and female standard or do I just screw on anyway,good Idea to cut that tip off female wasn't long enough,Thank you
