AirX wind generator Yaw/slip ring replacement. 

Helpful info thanks. No need for the scandalous disclaimer at beginning tho... ha. My generator had a different issue. All three windings on the alternator were shorted together, so the enamel on the wires must have worn or burned away.

Thanks for the information. I would have put more silicon grease every where. But that is just me,I love silicone grease, it helps keep out water coats things nice and stays put and works in all temperature, well unless you get it really hot.

Depending on the width of the bearing, sometimes you can find 2 bearings that you can put together to make the same width. This generally is a lot cheaper. These special bearings can be expensive.

I am not the only one that has trouble to get the yaw assembly out i see 😁

Great video! Thank you. My AirX Marine just stopped producing energy today. The blades are spinning as they always do (with the same noise and speed), even when the engine alternator charges the batteries to 14.1V, the unit stops spinning and goes to regulation mode. However, the led is not blinking neither on the regulation mode, nor while spinning. And there’s no output. Everything seems to be normal apart from the red led being always off. I couldn’t solve this.

Thanks Wayne you made that look easy, if you were to purchase wind gen's again would you buy those or is there another brand or type you like better.

Hello Wayne Great video Can you tell me what voltage your system is and what amps does it produce as my one is only creating at most 1 amp cant work out why this is a new unit

Could you please tell me where you are getting your new Yaw bearing etc. I bought the aluminum housing model FDH400 ( used ) of which I am sure is an AirX version. The previous owner let the blade hub get loose and it proceeded to semi wear out the Yaw bearing thus causing the Yaw contacts to become non-conductive mostly the middle ring. Any help would be more than appreciated. Thanks ahead of time.

Wayne, I reviewed the video and saw how you removed the yaw assembly and how you replaced the assembly. However, I saw nothing of how you fixed the basic problem of the wire connection. After you removed it, what did you do to fix the incomplete circuit problem?

Wayne, Good video, but I'm curious why you don't just go solar. No moving parts and no noise.

No bearing replacement?

Hey, great video, but, horrible audio. Thanks

Next time use a something to hold the brushes in place and after inserting the bearinbg and circlip , remove the string or shim.

What was the fault on your unit