Hey Alan, I have a question about the spacers that come with the main shaft on my 650x super combo kit. Do i put the both on top of the head? or use the 0.5mm on top and the 0.3mm between the main gear and second upside down bearing block. When i use both on top I have no play vertically. or do i use the the 0.5mm on top and the 0.3mm between the main gear and second bearing block(0.3mm spacer to touch the upside down bearing to hit that race) The manual is not very clear at all for that spacer step and/or placement. All i know for sure is i have no vertical play with both spacers on top or 1 on top and one on top of the main gear. Any tips on where they both actually go? its smooth both ways but Thanks! anything will help i just want a smooth spinning head with no vertical play that wont cause premature wear on the bearings or main gear. Thanks!
Yes it can i was going to grab one because the cgy 760r/ cgy760r (w/ programming box) was out of stock so i'm gonna use my ikon 2 for the 650x atm. I'd get the program box that comes with it(the 755 kit) that includes it on Helidirect.com i ordered a 16iz as well and a R7008sb receiver for the 18mz, its compatible. by the way idk if he reads and comments back on these videos lol but check the Futaba chart on Futabas website for receivers - radio compatability : futabausa.com/product-support/receiver-feature-charts/
@@jasonBucao671 Anytime man i have a few questions of my own about the spacers that come with main shaft ( 0.5mm and 0.3mm). with both i get no play. but do they both go no top or do i use one between the main gear and third bearing block to hit that bearing race or put both of them on top? I get no vertical play when using both on top. I just don't know if thats how you place both of them or 1 on top and 1 on top of the main gear like i mentioned. Thanks man!