Analysis and design of a flyback. Leakage inductance. Part 17 

Best video ever seen on leakage inductance

educational presentation. its good of you to have tackled this aspect of a high voltage flyback converter. its exactly the material i want to know and learn.

Robert, Heart felt thanks for taking up my current issue. Amazing how you simplify things. Can't wait for your following videos on this topic. I would also request you to show how an incorrect snubber design can make the snubber divert energy away from the load and also burn itself in the process. (You know how I keep falling into this "snubber trap" and burning the snubber resistance. I really want a permanent solution to this.) Thanks for sending me the MathCAD and TopSpice files. Regards, Anand

Great explanation

Thank you so much, this was very helpful!

Thank you so much

Can i use these equations for input 12v to out put12v 0.6a

Hello Sir , I am unable to find your video on clamp circuit ( snubber design) after your this video. Part 18 is transformer design

sir if input voltage decreases input max current increasing .what are the steps to handle?

I did not get how you calculated the value of capacitor and resistor for the snubber

Nice presentation, but the LC resonant circuit is a series resonant circuit, not a parallel resonant circuit. Analysis is correct though.

Is there somewhere I can download the document used in the presentation?

Hi Robert can i send you email about question in my power supply design

I cut out after 12 minutes because I couldn't take another "OK".

Hi Robert, I sent email to you about leakage inductance for Flybuck converter. I have learned the method you showed in Flyback converter. If you are free, can you check my email?