ATORCH DL24P 180W Electronic Load Tester

Подписаться 12 тыс.

Просмотров 12 тыс.

50% 1

In this video we test the ATORCH DL24P 180W Electronic Load Tester
Affiliate Links:
ATORCH DL24P 180W Electronic Load Tester: amzn.to/3JQAvPb
================
CONTACT: bradcagleyt@gmail.com
Business/Collaboration only. Please do not contact me for for personal project help, or advice.
If you need help join diysolarforum.com/ I'm active there, and many other knowledgeable members are available for help.
================
DISCLAIMER: These videos are documenting my own projects, and experiences. These projects, and activities can be dangerous. Do not try any of this at home, doing so will be at your own risk.

Опубликовано:

6 фев 2023

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 25

@mannyfragoza9652 8 месяцев назад

Im thinking on getting this exact unit. Thanks Brad

@FixingWithFriends 6 месяцев назад

Thanks for the run through.

@BradCagle 6 месяцев назад

You're welcome

@Wikidigia 8 месяцев назад

great job man. thanks.

@BradCagle 8 месяцев назад

Thanks!

@RinksRides 10 месяцев назад

so when the vreg for the 3.3V dies, don't waste your time trying to find a replacement. Just jerry rig a new voltage regulator in there. Left pin=GND, middle=Vin, Right=Vout. Your welcome. It's the little black chip center above the screen just under the black bracket for the heatsink.

@BradCagle 10 месяцев назад

Thanks for the tip!

@tatkosmolko1672 Год назад

Hi bought day before at official ali shop atorch for 35 dolls . Good to put some heatsink to shunt resistors and maybe even doubling diode or using more powerfull one and changing power transistor for better one. Have a nice day.

@BradCagle Год назад

Thanks for the info!

@stevepr100 5 месяцев назад

Hi, also purchased this (reviewed by others) beauty & been OK with it for about 30 or40 cycles....... The all I'm getting is ureg flashing on dispay😢😢 Any ideas people🤔 much appreciated if anyone knows a solution🙏

@tatkosmolko1672 5 месяцев назад

@@stevepr100 Hi i dont understand your problem with display but my unit falls down from table and display was bit weak, when i pressed displey down to mainboard, it shines as original. So i put hot glue small in all corners. So try to lightly press down the displey, mybe its just bad contact.

@stevepr100 5 месяцев назад

@@tatkosmolko1672 my bad.. I didn't explain correctly, where you can change from CC CR etc on display top right ish, all that mine shows are the letters (ureg) and I can't access any settings at all.. 😕

@tatkosmolko1672 5 месяцев назад

@@stevepr100 Ah so, never heard about problem like that. Only what i can imagine that UREG means , that U - Volts nead to calibrate. You can calibrate device against good known devices. You can reach settings of device by longer press of Start butt and there you will see many things in options. I have Setup version of DL24 V5.1. Its only for DC. Not other what i know to help you. And write if you will solve the problem. I wish you good luck :)