In this 10-15 Minute video, John shows some of the benefits of Civil 3D with Storm & Sanitary Analysis (SSA) In the Infrastructure Design suite workflow.
Yes. The Pipe size will update when you import back in the pipe networks. You can either have Civil 3D create a new network or update the existing networks. John
I changed the dimensions of pipe and elevation of pipe (slope) and junctions because the pipe are very small. I tried on civil 3D 2012 and everything is ok. On civil 3D 2013 no. Is any problem with 2013?
Great video! i have a question: can storm and sanitary analysis automatically update the pipe size? if the system is big (>200 pipes or so) and half needs to be updated, is going to be time consuming to manually increase the pipe size. Thank you again for the video
Great and simple video, I was wondering if you can use the same process for analysis of drainage systems such as ditches or open trenches, highways, runways, type of drainage systems. Thank you ...
Hello. Thank you for your videos. Please help with these two questions. 1. Some of my structures disappear from Civil3D after importing and updating the network from SSA. All of my structures are the same. In addition, one of my pipes flips over thus disconnecting from its outlet structure. What could cause this? 2. Is there a way of bringing the peak flow values into Civil3D in order to show them in the profile labeling? Thank you.
Hi John, Please how did you get your external flow to be 3 CFS? Did you get it from the run-off discharge? Which rainfall return period did you use? Thank you.
Hi, the file .stm that I have imported to civil 3D is update. But all pipe, elevation, dimension, etc, did not change in profile and plan. What to do to fix it? Thanks
A great tool but i have a question about the workflow. I have created catchments and flow paths in Autocad civil 2016 and referenced them to a structure. When I import them into SSA are several of them not left as subcatchments and entities as runoff coefficients are not present at all. Instead SSA seems to use a default value. Is this the way it works or is it anything wrong in my installation?
Sir Mike, I have got the following question, can you send me relevant tutorials or answer, please. Model foul flows using discharge units to BS EN 752. is there any example available please Produce Greenfield rate calculations using IH124 method. Allow the application of climate change factors to rainfall data. Typically 30%. Where and how can I apply climate change, please. I am looking for a response from you soon, please. Thanks for your taking time. Kind regards
Good information, do you created any Technology based Civil 3d video, Like Electrical power cabinet, Electrical Duct & 3D asset tagging. Please upload if you have , thanks @john Sayre
