AutoTrickler V4 tuning with N570 

A freely adjustable screw is not desirable in this case. Once the adjustment is right, it can stay there for all powders from ball powders up to something like H4350. Tilt angle only needs to change for the special powders like N570 where inserting a specific, measured shim is faster than trying to find that perfect screw adjustment again. Unless the adjustment has like scope turrets with numbers it's going to be harder to use, and much more expensive, for an adjustment that only affects a minority. Further, if it can be adjusted, many people will adjust it constantly to fix any performance problem which is only going to make it worse. Tilt angle is not a primary adjustment for tuning, it's a set and forget. It's just important to set.

@AutoTrickler ok sounds good. Maybe have a shim that can go between the rear mount and v4 that way you don't have to tilt scale out of level? Also I been using blc2 and the big tube throws really well but the trickler takes like 8 seconds to do the last 1 grain. Is that normal?

8 seconds is probably alright, it should ramp down smoothly. Email me and I can help you more.

If you can weigh an object on the scale and it's not fluctuating, you don't need a base under the scale. You can see in this video how stable it is and I'm moving around and talking quite a bit. Adjust the tilt to reach 0.20 and that should be all you need. If you need more advice email me.

The buffer value shifts the ramp down curve to a lower weight, so it just slows down and stops earlier. If you have big kernels it can help so the ramp down aims for 0.06 under and then when it reaches this, it will run at a constant minimum speed from there up to the target.

1. Less sensitive to thickness. More precise angle changes with larger shims. 2. It won't get in the way when emptying powder (moving around the V4). Yes you can put a shim here instead if you prefer, but I think it's easier under the scale.

A couple weeks ago. I sent an email to all customers and also all our dealers should have sent emails to all their customers too.

Tilting the scale is a lot more convenient and it doesn’t affect the scale’s accuracy in any way that matters for reloading.

Thanks

Hi, thank you for feedback but as I have said many times before this solution is more appropriate than an adjustment knob which would only lead users to believe it needs to be changed all the time. Adjusting the scale level by a degree or two has no effect on its weighing.

@@AutoTrickler needs to be changed enough to where you updated your app to have saved profiles for each powder.

@@wldott The new app has 5 profiles you can rename and save settings and target weights. If you need specific help with your V4 please email me. I try to only respond on RU-vid comments with general information but for specific questions please email me and I will help you.