Welp I can't make it to Lime Rock with my Cara. Sad. Anyways, let the parts cannon continue. Altering the fuel supply stuff changed how it behaves.
Doing the intake manifold removal job is really not that bad. You would need to do this if you had to do anything with your injectors such as cleaning/replacement/upgrade.
After doing it a second time I was able to remove everything and put it back in about an hour.
Chapters:
0:00 Intro
0:07 No throttle body hose thus no boost, what happens? (cold)
1:15 Checking intake manifold bolt pattern location
1:44 Remove intake manifold
4:20 Peeking inside the intake side of the head
5:40 Remove fuel rail to get injectors and pressure regulator
7:29 Remove injectors
9:14 Spare fuel rail no noise
9:27 Clean off old gasket
9:41 Remove fuel pressure regulator
10:17 thanks injectorspa for cleaning and checking my stuff
10:45 Fuel rail comparison original, spare, new
11:51 Reinstall everything
17:20 Once over and test - fail 6000ish rev limit but not as bouncy (spare rail and original pressure regulator)
19:54 Do it again. New rail and new pressure regulator (slightly higher than spec by 5psi)
21:08 Deleted some stuff
22:06 Try again
22:31 Cold engine rev 4000 limit
23:52 Warmed engine rev 5500 limit bouncy like before
24:17 Switch keisport 6100 rev limit less bouncy
25:27 Welp no Lime Rock for my Cara...
#suzukicara #autozamaz1 #f6a #dohc #engineissue #carmaintenance #troubleshooting #engine #motor #pg6sa #pg6ss #intakemanifold #fuelrail #fuelinjector #fuelinjection #regulator #fuel #howto #car #autozam #suzuki #mazda #keicar #jdm #carissues
2 авг 2024
