@ezboyrc553 I thought I heard you say you needed to make a splitter. I thought a while back I sent you some connectors and a no solder connector for direct power things like the winch from Holmes Hobbies.
I just installed my first Fusion pro 2300 kv. Much easier than I thought, very impressive performance too. I also picked up an RC4WD 8274 winch, tons of pulling power. If I could afford it I would have a Fusion Pro in all my rigs
I'm running a different radio because I switched to the two speed instead of dig, so i'm not sure, but i'm thinking that it goes through the receiver and would be okay.
Yes it can run 3s battery. The only way it would burn up is if the main power wire, hot and negative.was backwards, when you plugged it in, and that's hard to do.. If you just bought it, they have a pretty good Warranty program You just have to send it to them, and they will look at it and see if they want to replace it.
Hello, your videos are very good. I wanted to ask you if you could give me the link to the wheel extension, which will be 12mm, right? thank you so much!!
Sorry. I don't have a link for these wheel extensions i've had them for many years. I always just look them up on amazon. There are plenty to choose from. They are 12mm hex's & About 15mm wide
I honestly don't know why Axial just doesn't make the 2 speed transmission a standard feature same as what Traxxas does. Why make people have to tear apart the rig in order to get this option going?
Since you already have a TRX4, you can use that radio to control the jeep but you'll just need to pick up another Traxxas receiver. At least that way you'll have all the channels. I did that for my early Bronco last year. @@ezboyrc553
No, you don't have to take the transmission out for just a motor swap. You actually only have to remove the fake engine off the top and 2 more screws. I think. The motor comes out very easy.