Тёмный

Baxi solo part 2 fitting the sump 

The Mental Gas man
Подписаться 3,7 тыс.
Просмотров 4,2 тыс.
50% 1

All videos are for the intended use by gas safe registered engineers only, such procedures should not be copied or performed by non competent and unqualified persons.
3T Gas Ltd - Heating and Boiler repair specialists in West Midlands
www.3tgas.co.uk
0800 9997870
Instagram the_mental_gas_man
MENTalk mental health advocate
www.MENTalk.online
Baxi ,Worcester Bosch , Viessmann, vaillant, ATAG, main , megaflo, ferroli, Ravenheat, navien , grundfos, wilo, Heatgeek, Intergas , talon , heatrae sadia , adey, boiler repairs , boiler servicing, central heating , boiler installation, new boilers , power flushing , vdi2035, magna clean , adey chemicals , faulty pumps , faulty pcb’s , diverter valves , balancing , efficiently , gas engineers ‪@thementalgasman3tgasmainte317‬
@

Опубликовано:

 

19 фев 2022

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 16   
@ryandow3954
@ryandow3954 2 года назад
That boiler looks like new now! Great to see the end result 😎 that's me officially caught up with your entire back catalogue of videos now too 🤟
@MegaShan001
@MegaShan001 2 года назад
Absolutely fantastic pal Thanks 😊
@macpatel7810
@macpatel7810 2 года назад
Terrific. Great job. Just like new as you said.
@joncoke8208
@joncoke8208 2 года назад
He sounds like a right lad
@rodsurman6482
@rodsurman6482 Год назад
Just seen your video,well done getting it sorted,these boilers are a real trial to sort out,hope you don't have to replace a flow switch any time too soon. Cheers
@steveincork3669
@steveincork3669 Год назад
Had leak coming through sump. Simple fix so I thought to my horror and customer's. Turned out pin hole leak at the back of heat exchanger. Boiler seven years old. Only thing I could put the damage down to was contaminated water no magnetic filter fitted either.
@johndoherty2637
@johndoherty2637 2 года назад
Great video as always. Can you provide any advice. I've got a Baxi Solo He 30, 9 years old. It recently broke down and ignitor was replaced. A lot of water inside when the engineer opened up. The company that maintains the boiler has said they think there's a pinhole in the heat exchanger and I need a new boiler. The thing is the boiler is working away OK. No water from it and the only issue is I need to turn the thermostat on the boiler back a bit as when full up it signals overheat light sequence. I was thinking after seeing your video, could the sump seal be gone and not the heat exchanger?
@markennyee
@markennyee Год назад
Great video ? for you my flue seal outside has been leaking for 18 months and when the boiler is heating up there is a lot of steam coming out of the flue its like a fog would this cause a boiler to fail eventually ? i have had 2 gas service certificates issued since sounds dodgy to me and cut corners with safety checks
@horgan8227
@horgan8227 5 месяцев назад
Got a part number for the sump mate?
@julianhawker7672
@julianhawker7672 2 года назад
When are you going to take us along mountain biking then mate?
@thementalgasman3tgasmainte317
@thementalgasman3tgasmainte317 2 года назад
Where you based buddy ? , I haven’t been out since start on jan due to fracturing my pelvis, need to get back out soon tho
@paulhughes8724
@paulhughes8724 2 года назад
I keep getting loads of them where the ceramic part of the burner comes away from the metal part
@thementalgasman3tgasmainte317
@thementalgasman3tgasmainte317 2 года назад
Ye had quite a few the same myself , still don’t think they’re a bad boiler if looked after properly
@julianwebb8712
@julianwebb8712 Год назад
Some high temperature silicone should stick it back in place..…..needs to by fully cured before firing boiler though 😊
@pkumar5411
@pkumar5411 Год назад
you could have got someone else to hold the camera surely...
@robertstanway9893
@robertstanway9893 Год назад
Your far too polite. Every disrespect for idiots sticking in a flue analyzer and charging for a service. A friend had hers serviced on friday and she said previously nobody had. Sadly the bloke who actually 'serviced' didnt stick it back together right as it's got an ignition fault. Too many clowns in this industry '.. I blame Gas Safe . Standards are appalling in the domestic gas industry. Luckily I work on industrial plant were you cant get away with incompitence
Далее
▼КОРОЛЬ СОЖРАЛ ВСЕХ 👑🍗
29:48
Просмотров 456 тыс.
Wirtz pumps are really clever
12:05
Просмотров 13 млн
Baxi faulty fan & air pressure switch
14:18
Просмотров 10 тыс.
Potterton promax main heat exchanger replacement
8:59
BAXI 105E/HE LEAKING WATER - DIAPHRAGM CHANGE
7:01
Просмотров 20 тыс.