Great video man! I’ll be checking out your channel much more. I’ve been waiting for a install video of these for a while and to make it better I have the exact same bike! Thank you!
You just have to flip up the rubber grips on the outside, around 1-2 cm from the edge there is two pins to push in and pull out the inner weight. No need to use that hammer.
can I use the original cap at the end of the handlebars again with the new mirrors, because I find 100 euros just for the adapter quite expensive in the end.
I tried it (same bike) and it did not work. It took some cutting work to make cheap, aftermarket bar ends fit. I also refuse to pay the premium for motogadget bar end. Their stuff looks good but is overpriced imho.
I confrim that removing the stick from the pipe is a nigthmare....took me 10 to 15min on each to remove it like zou did with hammer.... but now i am done and happz with mz new bar end mirrors.
just got mine installed but, dude! how do you keep them clean. they are fingerprints magnets then you try to wipe it off and it just smear all over. Are having this issue as well?
I do notice that the mirrors vibrate more, but that could just because of the location; end if the bar vs the inside the handle bar. Either way, both mirrors are useless at high speeds. Lol
