BMW E89 z4 인테리어 트림교체방법 - E89 Z4 INTERIOR TRIM REMOVAL 

did this job yesterday after watching this and one other video. My objective was to replace the center ac vent piece. it took me about 90 minutes only because I was being super careful and because the dash didn't pop back in right away. If that is all you want to do, or you want to get the dash portion that has the ac controls on them, you do not need to remove or disconnect anything other than the housing around the key, the end cap on the passenger side (with door opened) and the housing around the audio. you will need to unscrew the audio just enough to access the two t15 hex bolts above it. So you can pull up the shifter boot with your hands, let it hang, pull up the center console with the sport, ebrake, idrive components on them with you hands, leave it loose which will allow you access to the bottom of the housing around the audio. I recommend a medium size towel between the radio and the center piece to prevent it from scratching. I recommend a plastic hook tool that comes with the trim panel removal kit only because it is a tight fit, maybe you can get your fingers in there. pull that housing straight back and off from the bottom then the sides, then the four phillips screws at the bottom of the audio, pull it out about 2 inches and it will allow you access to the two hex bolts using a stubby driver. the fitting around the key is pretty sturdy, and all of the pins are on the non key hole side of it so I recommend going from that side. the end cap on the passenger side by the vent is a little fragile, but work around it with a plastic pry too and it will pop off. make sure it goes back in behind the rubber weather stripping around the door. I recommend taking out all the t15 hex screws within the glove box, (apx 6) and just keep order as to where they came out from (some are slightly longer, but all the same circumference). if you are going for the ac vents alone, once you pop out the dash piece it will allow you access to the two bolts holding it in and you are there. so the only thing I am trying to help out with is that you do not need to disconnect any of the plugs until you get to the part you are trying to remove.

Really nice video....e89 is easier than e85 to disassemble...at least the center consol....I bought a Z4 with alu interior and will replace it with a wooden interior. ( perhaps next winter)

'Thank you for this video. This is the only instructional video of removing the Center Bezel and accessing the components in the Center Console. This was very beneficial. Too bad I cannot understand the your language. The video alone allowed me to accomplish what I needed to have done. Thank you.

정말 멋지네요

좋은참고 자료 감사해요!!

Hi. How do I get the door interior trim off? I loosened the Torx screw behind the handle and then at the front towards the cockpit I was also able to unclip the bar a bit. But from the middle to the back it is so tight that I was afraid to pull further. Didn’t want break / tear off anything. Can you help me with the question?

Hi, I've seen all your videos about the E89. I would like to change the interior like you. Where could I get all the carbon parts? I am really very interested and would be very helpful. Greetings from Spain

안녕하세요! Thank you for the great video. Do you by chance recorded the process of doing the water transfer print ? The result looks great from the video.

To hydrodip the main centre trim (the one with the heater controls) and the smaller trim with the light switch, how did you separate the aluminium bit from the fake black leather part? I need to cover the Aluminium parts but need to separate them from the leather area.

👍👍👍

Hello sir very nice explanation

Hi, thank you so much for the video, it really helped a lot. One question please, where can I get the idrive knob replacement same like the one in the video? Thanks in advance

Hello i need full aluminium interior , where i find this? Thk

저도 따라서 뜯기 시작해야 겠군요. ㅋㅋㅋ

how i can remove the door trims?

부서지면 또........재밋습니다.

where are the metal foot plates from please

Would you be interested in selling the centre console ?

구독과 좋아요 눌러눌러 ㅎ

혹시 영상에 나오는 카본파츠들 어디서 구매 할 수 있나요?

혹시 428i에 데시뇨범퍼 튜닝가능한가요??? Z4는알겠는데ㅠㅠ

안녕하세요 탈거한 인테리어 파츠 관심있는데요!

1빠~

부셔지면 또 사면된닼ㅋㅋㅋㅋㅋㅋㅋㅌㅌㅋㅌㅋㅌㅌㅌㅌㅌ