BMW F10/F11 520D oil change

Подписаться 1,3 тыс.

Просмотров 73 тыс.

50% 1

This video indicates the steps I took to change the oil and filter in a BMW F11. This is not an instructional video.
Music:
Vibe With Me by Joakim Karud / joakimkarud
Music promoted by Audio Library • Vibe With Me - Joakim ...
Myspace by kimengumi / kimengumi
Creative Commons - Attribution 3.0 Unported- CC BY 3.0
creativecommons....
Music promoted by Audio Library • Myspace - kimengumi (N...
Chill Soul Rap Instrumental by Nkato / nkato
Creative Commons - Attribution 3.0 Unported- CC BY 3.0
creativecommons....
Music promoted by Audio Library • Chill Soul Rap Instrum...

Опубликовано:

12 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 31

@ismxil.1 5 лет назад

Always use a torque wrench to tighten filter housing and sump plug. The spec is 25nm.

@stanstefanov3315 2 года назад

In 0:45 make sure before applying force undoing the sump plug plastic cover to unscrew the 10mm screw that holds it in place.

@vitalijssostaks2372 5 лет назад

"Shell Helix AG" oil not for this car. Should be "Shell Helix ECT C3" BMW LL-04 !!! Capacity 5.2l usually 5l will be ok.

@hosuandreiremus 4 года назад

Thank's for that. My owners manual specifies C3 or C4 oils, but does not give more detail than that.

@andreitanase8432 6 месяцев назад

what socket i need for oil filtre and for under the car plug ?

@CitizenSlide 4 года назад

Those yellow ramps I can see; are they a DIY solution (made from planks of wood) or did you buy them? And if so where from?

@hosuandreiremus 4 года назад

Made them from some scrap wood I had.

@cristando81 2 года назад

what is the height and length of the ramps

@matyas7210 5 лет назад

for what is that copper ring?

@hosuandreiremus 5 лет назад

hat is a copper washer. Copper is a fairly soft metal and it crushes to for a seal. it is beater to use copper instead of rubber rings because the rubber tends to degrade over time and cause leaks.

@TheRossa21 5 лет назад

its for the oil seal (under the car...) the screw where you release oil...

@massimilianomeneghesso3856 3 года назад

HOW MUCH ? €

@msanjay56 5 лет назад

Capacity engine oil

@nizamulkillerdot 5 лет назад

What is the engine oil capacity? People are waiting for a response

@hosuandreiremus 4 года назад

Best to check your owners manual.

@kerekesgabor1985 2 года назад

5.2 litres

@skywalker3852 3 месяца назад

5.0 to 5.2

@moky4241 3 года назад

Have same car however mine doesn't show the oil level? Any ideas?

@hosuandreiremus 3 года назад

When have you last changed it? Are you sure you have the correct level of oil? Does it show on the dip stick and not on the dash?

@moky4241 3 года назад

@@hosuandreiremus shows on dipstick. Not on the dash. I thought it should show on the idrive?

@hosuandreiremus 3 года назад

@@moky4241 it should show on the idrive. It generally only shows aster starting the engine and letting it idle. Have you checked with the engine on?

@TheRossa21 5 лет назад

dont follow what he done.... his car wasn't straight he has minimum 1 litre left in the oil chamber *(used oil ) this days anyone cand change oil and filters... well not correctly at the end you end up with less mileage on a change... if any of you plain to change oil... please dont do it following this video because is all wrong, Cheers

@hosuandreiremus 4 года назад

I agree, but I was doing this on my driveway and I don't benefit from a car lift. BMW oil drain interval is 18000 miles. I do my own oil drain in between the dealer service, and I do it with the limited tools I have.

@CitizenSlide 4 года назад

This method is not ‘all wrong’; but I always lower the car off the jacks when draining the sump and use a vacuum pump inserted through the dipstick tube to remove any further used oil, then jack the car back up again to replace the sump plug and shield. My identical car has now covered 210,000 miles and runs well with only a timing chain replacement at 170,000 miles.

@hosuandreiremus 4 года назад

Did you replace the timing chain as a preventative measure? Or did it give you indications tahat it needs changing?