I have a 1967 f100 factory 4x4 with a dana 44 3.54 gears ( I did take off the cover to make sure like you said to do here if i wasn't sure) and it said dana 44 and then the 46.13. So, my question is it has the four-bolt kingpin like you're saying the dana 30 here in you video has. I do have one more question can one swap the 1971 bronco dana 44 axle into a 1967-1972 ford half ton f100? I was told that the bronco used the front axles from the half tons pickups from the 60s an 70s. I wonder what the dimensions are for the wedges and coil spring mounts cause if those are the same I bet it would work.
My Dana 30 s with trak lok were 4 pinion ramp design and the 7-1/2”? Ring gear. King pin caps with spindles and bearings Just like the future Dana 60 front axles.
+TheBroncoGraveyard sorry I wasn't clear🙄I want to do a solid front axle swap for my Nissan Pathfinder and I would like to use an axle from a bronco let's say. Where can I find one?
I'm not sure on the widths of the pathfinder, but you're best bet is to again check out some of the bronco and ford truck forums like: classicbroncos.com/forums or www.fullsizebronco.com/forum keep in mind that an early bronco axle will be narrower than a later model full size bronco axle
