Canam outlander and renegade (gen2) trailing arm bearing removal. 

Thanks for the video! I am currently in the middle of installing some S3 stretched a-arms and trailing arms and when I got to the trailing arms I was a little unsure of how to get those out and I was stoaked that I found your video! Thanks again!! 🤘

Thanks for that! Now to find a video that shows how they pressed the new bearings in. :)

Great easy way do it !

Thanks ole boy u have no clue how much your video help me with this process. Update.. when tryin to install swing arms the outter cap keeps falling out, i took the cap flipped it inside out and put the seal over it to hold it in.. hope this may save someone headaches. Also its only 2 flat washers. 1 on each swing arm on the outside before the nut. Extremely hard to put back in either way, alot of pryin and banging. Anyone have any better ideas?

How did you get the swaybar bolt out? Mine is hard to get out

Why did you replace the bearings? Is it since they had play movement like mine?

You're brave, 1 slip and you break your knuckle.

😎👊🍻

what kind are they!!!????? where did you get them from i can’t find any for mine