Case IH Loader Connection 

These 844's are really good tractors, even when people turbo'd them to get them more livelier out of the D 246 engine. No doubt the 844 and the 56series were the best tractors that International and Case International ever made.

In the UK there not very popular,

There are kicking about even the unusual XLN cab, plenty talk about in the The Farming Fourm the UK website over years. Also your 844 and my 956 are completely different with back end and hydraulics system to the 74, 84, 85, 95, ect.

Did you ever find a way to tap into the high pressure side of your 385 for a loader attachment?

@@shawnpadgett2018 No sir. I was looking to upgrade my old unit, but once the pandemic set in, I just made due with the 3 point and creative attachments. The amount of time and effort to add a scoop to my 385 is just too much. I love my 385 though. :-)

Thanks for the response. I have it all hooked up but can’t figure out how to get the pressure to make the loader go up and down. My set up is just like the video but it just won’t work

After two days we just got it. The high pressure supply line is the pressure side of the power steering. That is the line directly under the hydraulic filter. It works like a champ!!!

@@shawnpadgett2018 👍👍

going into the top transmission filler plug causes it to bubble which in turn causes cavitation

Why isnt it for you? Explain in detail

@@jimjones4600 he said in the video that he was explaining the loader hookups for someone who had commented asking him to do so. I wasn't that person but I did enjoy the video and I like seeing people helping other people.

@@wannabefarmer6056 Why would anyone think it was you that asked for the video? Are you important or something

@@jimjones4600 I am no more important than anyone else. It was not implied that the content was for "just"me and it was not implied that I am more important. I was merely expressing my gratitude to PA farms for sharing with us.

@@wannabefarmer6056 Then why say "even though it wasnt for me "

Hey buddy. Got a question. When you hooked up the line to your rear remotes did you have to put a 90 quick disconnect fitting on it or did you just plug them straight in. If there’s anyway you could send me a couple of pictures of how you ran your lines from the controller back to your remotes would be in your debt hahaha. Thanks Evan.

@@evanmeyers622 Evan I actually ran them from the power beyond it's where the rear remotes connect to underneath the tractor. This was the case at the time I just didn't want to confuse the situation more by adding that to my question since it doesn't make a difference. If you're running from the rear remotes yes 90 because you are essentially running it back a hundred eighty degrees back to the loader and think there is too much of a bend. I guess you can try it. It all depends how you want to connect it to the rear remotes if it's temporary then you put a quick connect if it's permanent then run a direct line with the 90. If you're connecting it at the bottom of the tractor then I believe I used the 90 there as well . As far as the lines there only two one is the pressure side and one is the return.

Did you ever find a way to tap into the high pressure side on your 385?